hykolity I870000905A1 31 Inch Fire Pit with Grill Instruction Manual
- June 17, 2024
- Hykolity
Table of Contents
hykolity I870000905A1 31 Inch Fire Pit with Grill
Assembly Instruction
31 in. Fire Pit with grill Item No.#I870000905A1
WARNING
FOR YOUR SAFETY
- Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
- Read the installation, operation, and maintenance instructions thoroughly before installing or servicing this equipment.
- Failure to follow these instructions could result in fire or explosion, which could cause property damage,
WARNING
For Outdoor Use Only
SAFETY INFORMATION
WARNING
FOR YOUR SAFETY
-
This appliance is for outdoor use only, and shall NOT be used in a building, garage or any other enclosed area.
-
Do NOT use this fire pit for indoor heating. TOXIC carbon monoxide fumes can accumulate and cause asphyxiation.
-
This fire pit is NOT for commercial use.
-
This fire pit is NOT to be operated by children.
-
This fire pit is NOT to be used in or on boats or recreational vehicles.
-
Always use in accordance with all applicable local, state and national codes. Contact your local fire department for details on outdoor burning.
-
When using this fire pit, exercise the same precautions you would with any open fire.
-
The use of alcohol, prescription or non-prescription drugs may impair the consumer’s ability to properly assemble or safely operate this fire pit.
-
Do NOT use this fire pit without reading the entire “Owner’s Manual”.
-
This fire pit is for use with dry, seasonal hardwood. It will burn hotter, more completely and create less smoke.
-
Do NOT burn charcoal briquets, lump charcoal, manufactured logs, driftwood, trash, leaves, paper, cardboard, plywood, painted or stained or pressure treated wood. Avoid using softwoods such as pine or cedar that can throw sparks.
-
Do NOT alter this fire pit in any manner.
-
Do NOT use this fire pit until it is COMPLETELY assembled and all parts are securely fastened and tightened.
-
Do NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance
-
Do NOT store or use an LP gas cylinder within 10 feet (3.05m) of this fire pit while it is in operation.
-
Do NOT use this fire pit near automobiles, trucks, vans or recreational vehicles.
-
Do NOT use in an explosive atmosphere. Keep outdoor area clean and free from combustible materials, gasoline and other flammable liquids.
-
Do NOT use this fire pit under any overhead or near any unprotected combustible constructions. Avoid using near or under overhanging trees and shrubs.
-
Always use this fire pit on a hard, level non-combustible surface such as concrete, rock or stone. An asphalt or blacktop surface may not be acceptable for this purpose. Do NOT use on wooden decks.
-
Always empty this fire pit before each use.
-
Do NOT wear flammable or loose clothing when operating this fire pit.
-
Do NOT use in windy conditions.
-
Do NOT use this fire pit unless fire screen is securely in place.
-
Do NOT use gasoline, kerosene, diesel fuel, lighter fluid or alcohol to light or relight fires.
-
Keep all electrical cords away from a hot
fire pit. -
All surfaces of this fire pit are hot when in operation. To avoid burns, do NOT touch fire pit until it has completely cooled unless you are wearing protective gear (Potholders, gloves, BBQ mittens, hot pads & etc.). Never touch ashes or coals to see if they are hot.
-
Do NOT leave a lit firepit unattended,especially around children and pets.
-
Do NOT attempt to moveor store this firepit until all ashes and coals are completely extinguished.
-
Do NOT remove ashes or coals until they are completely and fully extinguished.
-
Use heat-resistant gloves or hotpads when contacting handles.
-
Use long, sturdy fire pit tools when adding or moving logs.
-
Do NOT overload the firepit. Don’t Add Additional firewood until the fire burns down. NOTICE: If any portion of the bowled or spark guards of this firepit are glowing red it is overloaded.
-
Do NOT lean over this firepit when lighting or when in use.
-
Do NOT place a hot firescreen firepits tools onto combustible surfaces succah’s grass, wooden deck or furniture.
-
Avoid breathing smokefromthefireandavoid getting it into your eyes.
-
This fire pit should be thoroughly inspected and cleaned on regular basis.
-
After a period of storage and/ornon-use,check for sigh’s of damage and creosote build-up. Do NOT operate until necessary repairs and/or cleanup executed.
-
Deaths, serious injury or damage property may occur if the above not followed exactly.
CAUTION: It is not recommended to use this fire pit (fire place) on a wooden or other combustible surface or any surface that is not entirely resistant to high heat. However, if you intend to use this item on a wooden deck other combustible surface or any surface that is not entirely resistant to high heat, you must use a non-flammable and heat resistant material such as concrete pavers, brick or stone between thefirepit (fire place) and the surface.
WARNING: Fuels used in wood or charcoal burning appliances, and the products of combustion of such fuels, contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
PACKAGE CONTENTS
| Par# | Desc | Qty |
|---|---|---|
| 1 | Small grill | 1 |
| 2 | Biggrill | 1 |
| 3 | lograck | 1 |
| 4 | Support post | 1 |
| 5 | post holder | 1 |
| 6 | 2-bracket outer rim | 2 |
| 7 | 1-bracket outer rim | 2 |
| 8 | Firebowl | 1 |
| 9 | Leg | 4 |
| 10 | Poker | 1 |
Hardware Pack
| A | M6x15mm | X 6+1 | |
|---|---|---|---|
| B | M6mm | X 6+1 | |
| C | MB mm | X 10+1 | |
| D | 0 8mm | X 10+1 | |
| E | M8x20mm | x3 | |
| F | M6 Wrench | X 1 | |
| G | M8 Wrench | X 1 | |
| H | X 1 |
Assembly
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present.
Place all parts on a soft, level surface for assembly.
-
Assemble each Leg(8) using two M6 Nut(C) with Two washers(D) and tight it with M6 Wrench(F).
-
Assemble the 2-bracket Outer Rim (6) -2pcs and 1-bracket Outer Rim(7) with 6pcs M6 screws(A) and 6pcs M6 Nuts(B).DO NOT cross threaded. See Fig 2.
Note: Connect the 2 different outer rims one with another.
-
Attach the Poster Holder(5) onto the side wall of the fire bowl with 2pcs M8 nuts(C). TightenthenutandDO NOT cross threaded.See Fig.3
-
Place the Support Post(4) into the holder.
Secure it with a M8 Wing Bolt(E).See Fig.4
-
Attach the Big grill and small grill onto the post. Adjust the grill to the desired height.
Then secure it with two M8 Wing Bolt(E). See Fig.5
DO NOT adjust the grate height during use bare handedly.
DO NOT overload on the cook grate(max. 5lb)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>