F F 74×105 FF PZP Probe Floa Instruction Manual
- June 17, 2024
- F F
Table of Contents
PZP probe
Float probe
Do not dispose of this device in the trash along with other waste!
According to the Law on Waste, electro coming from households free of charge
and can give any amount to up to that end point of collection, as well as to
store theoccasion of the purchase of new equipment (in accordance with the
principle of old-for-new, regardless of brand). Electro thrown in the trash
or abandoned in nature, pose a threat to the environment and human health.
Purpose
The PZP float probe is designed for use in clean water tanks. It is equipped with electromechanical switches that signal the position of the probe based on which the presence or absence of water can be detected.
Fuctioning
A 3-wire cable is attached to the probe (colours: black, brown, blue). Raising the probe to an angle of +45 degrees (or higher) will close the contact between the black and brown wires. Lowering the probe at an angle of -45 degrees (or lower) will close the contact between the black and blue wires.
Probe positioning| Level detection| Internal contacts
positioning
---|---|---
| High liquid level|
| Low
liquid level|
Wiring diagram
Example of direct pump control
Technical data
voltage | ≤250 V AC |
---|---|
maximum load current (AC-1) | 8 A |
mechanical durability | 50.000 cycles |
electrical durability | 20.000 cycles |
working temperature terminal | ≤80°C |
cable | 3-wire (integrated with probe) |
cable leght | 3 m |
cable diameter | 7,5 mm |
wire cross-section | 1.5 mm² |
dimensions | 142×93×42 mm |
ingress protection | IP68 |
Warranty
F&F products are covered by a 24-month warranty from the date of purchase. The
warranty is only valid with proof of purchase.
Contact your dealer or contact us directly.
F&F Filipowski L.P.
Konstantynowska 79/81, 95-200 Pabianice, POLAND
phone/fax (+48 42) 215 23 83 / (+48 42) 227 09 71
www.fif.com.pl; e-mail:
biuro@fif.com.pl
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>