the t bone 406584 GigA Pro Dual Rackmount Instruction Manual
- June 17, 2024
- the t bone
Table of Contents
406584 GigA Pro Dual Rackmount
Assembly instructions item no. 406584 “the t.bone GigA Pro Dual
Rackmount”
Rack kit for attaching two GigA Pro receivers or the t.bone IEM D2.4 on 1U
-
Mount the rack ears (1) on the outer sides using the included screws (5).
-
Screw the H-connection (2) to the inside back of the devices, To do this, take the screws that are mounted on the housing.
-
The I-connectors (3) go on the inside of the devices. One at the top/front where a screw is mounted to the housing. Please use the screw from the housing.
The 2nd I-connection (3) goes on the bottom of the devices, at the front or back.
To do this you must remove the rubber foot.
Below you will find the screw you will use for this.
-
The plugs (4) are used to cover the holes in the rack ears for the antennas when they are not in use.