ALL SOLAR CENTRAL SF021 Solar Ceramic Frog Instruction Manual

: June 17, 2024
: ALL SOLAR CENTRAL

Table of Contents

SF021 Solar Ceramic Frog Instructions
By All Solar Central

SF021 Solar Ceramic Frog Instructions

By All Solar Central

www.allsolarcentral.com

Thank you from the entire ASC family for purchasing an ASC solar product! Please read this entire booklet before assembly.

Package contents:

1 x Frog
1 x Reservoir
1 x Water Pipe and Rubber Bung
1 x Water Pump
1 x Solar Panel with Bracket
1 x Extension Tube
1 x Ground Spike

Notes: If there is any damage to the product or missing parts, please contact us at 1-626-582-8898 or www.allsolarcentral.com/contactus

Assembly Steps:

1. Attach Water Pipe to the Frog Base with a provided Rubber Bung

RUBBER BUNG
FROG BASE
WATER PIPE

2. Attach the Frog onto the Reservoir. Put the pipe through the hole on top surface of the Reservoir.

WATER PIPE
FROG
RESERVOIR

3. Attach the pump to the water pipe and exit through a hole on the back side of the Reservoir.

PUMP
CABLE HOLE
PUMP POWER CABLE

4. Add appropriate amount of clean water into the Reservoir and make sure the pump is fully submerged in the water.

5. Connect the bracket, tubes and spike together. Then attach the solar panel to the bracket. Slide the holding bracket into the inside lip of the top half of the solar panel frame. The bracket holds the weight of the solar panel. The solar panel can be adjusted for optimal sunlight by using the wingnut. Please see the diagram.

SOLAR PANEL
BRACKET
TUBE
SPIKE

6. Insert the spike into the ground. Position the solar panel so it’s facing south (in northern hemisphere) as much as possible to maximize daylight hours. It is important to angle the solar panel to face the sun when the sun is at its highest point. Ensure the solar panel is not shaded by trees, shrubs or buildings.

CORRECT POSITION

7. Connect the Pump to the back side of the Solar Panel. IMPORTANT!! Slightly twist the connectors when connecting to make sure the rubber seals are fully in the grooves.

SOLAR PANEL
PUMP POWER CORD
PUMP PLUG HOLE
PUMP PLUG

8. SOLAR PUMP FUNCTIONS
This pump runs from direct sunlight. The pumps performance is directly related to the amount and strength of sunlight received by the solar panel. This solar pump is designed primarily to operate in summer months but can also work in spring and autumn if there is direct sunlight. Notes: This model DOES NOT come with a battery, so the pump will only work when the solar panel is in sunlight. Please visit www.allsolarcentral.com/ for additional solar water pump kits.

9. PUMP MAINTENANCE

If you find the pump starts losing power or stops working, please clean the pump filter and impeller with clean water.

FRONT CASE
FILTER
IMPELLER COVER
IMPELLER
PUMP

10. TROUBLE SHOOTING

Check to see if the solar panel, pump and led light are connected properly
Check to see if the solar panel is correctly positioned facing the sun. Please ensure the solar panel is not in the shade or obstructed by trees, shrubs or a building (see step 2).
Check water level and make sure the pump is fully submerged in water
Check to see if the pump filter/impeller is blocked by debris
Check to see if the fountain tubing is blocked by kinks or obstructions
Check the pump. It may be “air locked”. Turn the pump on/off switch several times to clear any air that may have been trapped.

11. WINTER PROTECTION
Indoor storage is recommended during winter months. Normal operating temperature is between 50 and 113 °F.

Please visit www.allsolarcentral.com for more products and offers.