BROAN NUTONE RDFQF Premium Radiation Damper Installation Guide
- June 17, 2024
- Broan NuTone
Table of Contents
RDFQF
Premium
Radiation Damper
INSTALLATION GUIDE
Easy installation
READ AND SAVE THESE INSTRUCTIONS
Installer: leave this guide with homeowner.
Register your product online at:
www.broan.com/register or
www.nutone.com/register.
Usage
For use with 1, 2, or 3-Hour-Rated Floor-Ceiling and Roof-Ceiling Designs.
Flat Ceiling / Horizontal Mount Only.
For use with the following ventilation fan models:
Broan QTRE080, QTRE080C2S, QTRE080R, QTRE110, QTXE050, QTXE080, QTXE110,
SSQTXE110, SSQTXE080, QTR110F, QTRE110F, QTR080F and QTRE080F
NuTone QTREN080, QTREN110, QTXEN050, QTXEN080, QTXEN110, Smart-Sense,
QTRN110F, QTREN110F, QTRN080F and QTREN080F
SEE DETAILS ON UL CLASSIFICATION MARKING ON PRODUCT
Preparation
Install Hanger Bar Mounting Channels
-
Fasten mounting channels to the fan housing using screws (supplied with fan). Make sure tabs face “up” as shown. Use lower set of hole to mount the fan flush with bottom of drywall.
Attach Damper Assembly to Fan -
Position RADIATION DAMPER (A) down inside the FAN HOUSING (B). Align slots in the damper with holes in the fan housing. Secure damper with (4) #8 X 3/8” HEX HEAD SHEET METAL SCREWS (C) supplied in damper parts bag. Do not over tighten.
Install Fan / Radiation Damper In Ceiling
MAKE SURE FINISHED CEILING IS FLUSH WITH
BOTTOM EDGE OF FAN HOUSING. -
If the fan assembly is hung from the structure above, MINIMUM 12 GAUGE STEEL WIRE (3MM) must be used to suspend the fan. Use one wire on each side of fan and secure to mounting channels as shown.
-
If the fan is directly mounted to adjacent ceiling structure, use #8 (M4) SHEET METAL SCREWS OR ¼” DIAMETER BOLTS WITH NUTS to fasten SLIDING HANGER BARS. Sliding hanger bars are provided to allow for accurate positioning of fan between ceiling members.
Finish Fan Installation
-
Follow instructions packed with the fan to connect ductwork and electrical wiring.
-
Install corrugated MASK to protect damper and fan from drywall spray, construction dust, etc.
-
Finish ceiling around damper housing. Ceiling opening must be no larger than the outside of the radiation damper.
Install Grille
REMOVE THE MASK BEFORE INSTALLING GRILLE OR OPERATING FAN. -
Squeeze GRILLE SPRINGS and slide into tabs on the radiation damper frame. Push GRILLE until it’s tight against ceiling surface.
-
Follow instructions packed with the fan to finish the installation.
Service Feature For Fans
If your ventilation fan needs service, the inner damper can be removed from
the outer frame without disturbing the surrounding ceiling material.
Remove the grille.
Remove (4) screws, then lower the inner damper to access ventilation fan.
Replace the inner damper before operating fan.
Warranty
Limited Warranty
Warranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to
the original consumer purchaser of its product (“you”) that the product (the
“Product”) will be free from material defects in the Product or its
workmanship for a period of one (1) year from the date of original purchase.
The limited warranty period for any replacement parts provided by the Company
and for any Products repaired or replaced under this limited warranty shall be
the remainder of the original warranty period.
This warranty does not cover speed controls, fluorescent lamp starters, tubes,
halogen and incandescent bulbs, fuses, filters, ducts, roof caps, wall caps
and other accessories for ducting that may be purchased separately and
installed with the Product. This warranty also does not cover (a) normal
maintenance and service, (b) normal wear and tear, (c) any Products or parts
which have been subject to misuse, abuse, abnormal usage, negligence,
accident, improper or insufficient maintenance, storage or repair (other than
repair by the Company), (d) damage caused by faulty installation, or
installation or use contrary to recommendations or instructions, (e) any
Product that has been moved from its original point of installation, (f)
damage caused by environmental or natural elements, (g) damage in transit, (h)
natural wear of finish, (i) Products in commercial or nonresidential use, or
(j) damage caused by fire, flood or other act of God. This warranty covers
only Products sold to original consumers in the United States by the Company
or U.S. distributors authorized by the Company.
This warranty supersedes all prior warranties and is not transferable from the
original consumer purchaser.
No Other Warranties : This Limited Warranty contains the Company’s sole
obligation and your sole remedy for defective products. The foregoing
warranties are exclusive and in lieu of any other warranties, express or
implied. THE COMPANY DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS WARRANTIES, AND
DISCLAIMS AND EXCLUDES ALL WARRANTIES IMPLIED BY LAW, INCLUDING WITHOUT
LIMITATION THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. To
the extent that applicable law prohibits the exclusion of implied warranties,
the duration of any applicable implied warranty is limited to the period
specified for the express warranty above. Some states do not allow limitations
on how long an implied warranty lasts, so the above limitation may not apply
to you. Any oral or written description of the Product is for the sole
purpose of identifying it and shall not be construed as an express warranty.
Whenever possible, each provision of this Limited Warranty shall be
interpreted in such manner as to be effective and valid under applicable law,
but if any provision is held to be prohibited or invalid, such provision shall
be ineffective only to the extent of such prohibition or invalidity, without
invalidating the remainder of such provision or the other remaining provisions
of the Limited Warranty.
Remedy: During the applicable limited warranty period, the Company will, at
its option, provide replacement parts for, or repair or replace, without
charge, any Product or part thereof, to the extent the Company finds it to be
covered by and in breach of this limited warranty under normal use and
service. The Company will ship the repaired or replaced Product or replacement
parts to you at no charge. You are responsible for all costs for removal,
reinstallation and shipping, insurance or other freight charges incurred in
the shipment of the Product or part to the Company. If you must send the
Product or part to the Company, as in- structed by the Company, you must
properly pack the Product or part—the Company is not responsible for damage in
transit. The Company reserves the right to utilize reconditioned, refurbished,
repaired or remanufactured Products or parts in the warranty repair or
replacement process. Such Products and parts will be comparable in function
and performance to an original Product or part and warranted for the remainder
of the original warranty period.
Exclusion of Damages:
THE COMPANY’S OBLIGATION TO PROVIDE REPLACEMENT PARTS, OR REPAIR OR REPLACE,
AT THE COMPANY’S OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS
LIMITED WARRANTY AND THE COMPANY’S SOLE AND EXCLUSIVE OBLIGATION. THE COMPANY
SHALL NOT BE LIABLE FOR INCIDENTAL, INDIRECT, CONSEQUENTIAL OR SPECIAL DAMAGES
ARISING OUT OF OR IN CONNEC- TION WITH THE PRODUCT, ITS USE OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights, and you may also have
other rights, which vary from state to state.
This warranty covers only replacement or repair of defective Products or parts
thereof at the Company’s main facility and does not include the cost of field
service travel and living expenses.
Any assistance the Company provides to or procures for you outside the terms,
limitations or exclusions of this limited warranty will not constitute a
waiver of such terms, limitations or exclusions, nor will such assistance
extend or revive the warranty.
The Company will not reimburse you for any expenses incurred by you in
repairing or replacing any defective Product, except for those incurred with
the Company’s prior written permission.
How to Obtain Warranty Service:
To qualify for warranty service, you must (a) notify the Company at the
address or telephone number stated below within seven (7) days of discovering
the covered defect, (b) give the model number and part identification and (c)
describe the nature of any defect in the Product or part. At the time of
requesting warranty service, you must present evidence of the original
purchase date. If you cannot provide a copy of the original written limited
warranty, then the terms of the Company’s most current written limited
warranty for your particular product will control. The most current limited
written warranties for the Company’s products can be found at
www.broan.com . Broan-NuTone LLC 926 West State Street
Hartford, WI 53027 www.broan.com
800-637-1453
99045238B
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>