MONOGRAM ZKR36R, ZKR72R Integrated Panel Refrigerator Installation Guide
- June 4, 2024
- MONOGRAM
Table of Contents
MONOGRAM ZKR36R, ZKR72R Integrated Panel Refrigerator Installation Guide
Before you begin – Read these instructions completely and carefully.
Note to Installer: Be sure to leave these instructions with the Consumer.
Note to Consumer: Keep these instructions with your Installation
Instructions for future reference.
WARNING
Electrical Shock Hazard.
To avoid the risk of electric shock, make sure the power cord is not plugged
into the wall outlet.
WARNING
Tip Over Hazard.
This appliance is top heavy. Use extreme caution with moving to prevent
tipping over which could result in death or serious injury.
Kit provides components to install product(s) in an opening which is 24” deep.
Parts List
- Water line jumper (72” only)
- Water fitting tee (72” only)
- 2 power cords (One cord on 36”)
- RH and LH Case side trims
- Case top trim
-
8 Phillips head trim screws
-
10 Phillips head trim screws
- 2 Spacer trim side (72” only)
- Toe Kick (36” only)
Tools and Materials Required:
- Adjustable wrench
-
2 Phillips screwdriver
- 1/4” driver / socket
Installation Instructions
CHANGE POWER CORD
Longer power cords are required for retro fit installation.
Power cords are included in the Retro Trim Kit.
Replace power cords on both units. Both units can be plugged into the same
electrical supply receptacle.
Remove existing short power cord with string assembly:
- Remove 1/4” hex screws attaching rear access cover.
- Unplug 3-pin power cord connector inside the machine compartment (press on sides to release locking tabs).
- Remove power cord green ground 1/4” hex screw.
- Remove strain relief 1/4” hex screw.
Install new longer power cord:
- Plug in the 3-pin connector (make sure locking tabs are engaged).
- Install the power cord green ground screw.
- Install the power cord strain relief.
WARNING
Electrical Shock Hazard.
To avoid the risk of electric shock, make sure to re-install the ground screw
after changing the power cord.
Replace rear access cover. Make sure the power cord and ground wire are
properly routed through the access cover cut-out.
Repeat all steps for second unit.
CASE TRIM INSTALLATION
-
Install the trim kit side rails to the exposed right and left case walls using the provided #8 Phillips head screws – 14 screws per side. Install spacer on each side of the 72” dual installation.
-
Fit the top trim and side trim rails together by sliding the exposed edges of the corner trim into the right and left trim kit side rails. Align and drive the two number 10-24 Phillips head screws into the screw bosses in the side rails to ensure the top trim is snugly fit to the side rails.
FOLLOW ALL INSTALLATION INSTRUCTIONS PROVIDED WITH THE APPLIANCE TO COMPLETE THE DUAL INSTALLATION.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>