SC95 Slash Cry Baby Classic Wah Instruction Manual
- June 17, 2024
- SLASH
Table of Contents
SC95 Slash Cry Baby Classic Wah
Product Information
Specifications
- Inductor : Custom wound low noise 560 millihenry high Q torrid
- Input Impedance : 0.7 MEG
- Output Impedance : 102 dB A-weighted
- Sweep Range : Located on both sides of the pedal
- Signal To Noise : 102 dB A-weighted
- Bypass: Hardwire DPDT bypass
- Power Requirements : +9 VDC
Product Usage Instructions
Powering the Slash Cry Baby Classic Wah
The Slash Cry Baby Classic Wah can be powered in three ways:
- Using one 9-volt battery: Open the bottom of the pedal to access the battery compartment. Insert a 9-volt battery and close the compartment securely.
- Using a 9-volt AC adapter: Connect a compatible 9-volt AC adapter, such as the Dunlop ECB003/ECB003EU, to the power input jack on the pedal.
- Using a DC BrickTM power supply: Connect a DC BrickTM power supply to the power input jack on the pedal.
Setup Instructions
To set up the Slash Cry Baby Classic Wah, follow these steps:
- Connect your guitar or instrument to the input jack on the pedal.
- Connect an amplifier or audio interface to the output jack on the pedal.
- Ensure that the pedal is powered using one of the methods mentioned in the “Powering the Slash Cry Baby Classic Wah” section.
- Adjust the sweep range controls located on both sides of the pedal to your desired settings.
FAQ
- Q: How do I change the battery in the pedal?
- A : To change the battery, open the bottom of the pedal, remove the old battery, insert a new 9-volt battery, and securely close the compartment.
- Q: Can I use a different brand of AC adapter?
- A : Yes, as long as the AC adapter provides a 9-volt power output and is compatible with the pedal’s power input jack.
POWER
The Slash Cry Baby Classic Wah is powered by one 9-volt battery (accessed via the bottom of the pedal), a 9-volt AC adapter such as the Dunlop ECB003/ECB003EU, or a DC Brick™ power supply.
SETUP INSTRUCTIONS
- Run a shielded instrument cable from your guitar to the SC95’s Instrument jack.
- Run another shielded instrument cable from the SC95’s Amplifier jack into your amplifier input.
- Turn on the amplifier and begin playing.
- To turn the pedal on/off, push the toe of the pedal down until you feel a “click”.
- By rocking your foot back and forth on the pedal, you can change the effect that the SC95 has on the tone of your instrument instantaneously.
- Blue LEDs on both sides of the pedal indicate ON/OFF status.
SPECIFICATIONS
Inductor: Custom wound low noise 560 millihenry high “Q” toroid
Input Impedance: .7 MEG
Output Impedance: <1 K
Sweep range: 340 Hz – 1.7 KHz
Signal To Noise: >102 dB A-weighted
Bypass: Hardwire DPDT bypass
Effect on LEDs : Located on both sides of the pedal
Power Requirements: +9 VDC @ <3 ma., 5.5mm x 2.1mm positive barrel & negative center or standard 9-volt battery.
DUNLOP MANUFACTURING, INC. P.O. BOX 846 BENICIA, CA 94510
- U.S.A. TEL: 1-707-745-2722
- FAX : 1-707-745-2658
- Jimdunlop.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>