Shenzhen Harmoniq Labs LYTTE True Wireless Earphones User Guide
- June 5, 2024
- Shenzhen Harmoniq Labs
Table of Contents
Shenzhen Harmoniq Labs LYTTE True Wireless Earphones User Guide
Getting Charged & Started
- First-time use: Inset the earphones into the charging case. Use the USB-C port on the case to charge both the case and the earphones for a least 10 minutes. Do not take out the earphones in this step.
- Regular use: when the earphones are low on battery, 20 minutes of charging can provide you approximately 1 hour of playtime.
Battery
Case is Charging
Case Battery Full
Choosing the Best Fit Ear Adapters
Inserting the Earphones into the Ears
Pairing with a Bluetooth Device
Factory reset
Call/Music Operations
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation. Warning: Changes or modifications not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help.
RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
“This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.”
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>