fanco W-CFFCINID22WH-WC Wall Control DC For Ceiling Fan Instruction Manual

fanco W-CFFCINID22WH-WC Wall Control DC For Ceiling Fan

Product Information

Specifications

• Product: Wall Control
• Version: 2.0
• Compatibility: Suitable for Fanco fans with no light

Product Usage Instructions

Important Safety Information
Please read and follow all instructions carefully to ensure safe and proper usage of the Wall Control:

1. Make sure the Wall Control is only used with Fanco fans that do not have a light. Using it with any other type of fan may result in damage or malfunction.
2. All wiring must be performed by a licensed electrician. Failure to do so may void the warranty.

Wiring Diagram – Wall Control
Refer to the following wiring diagram when installing the Wall Control:

FAQ

• Can I use the Wall Control with a fan that has a light?
  No, the Wall Control is only designed for use with Fanco fans that do not have a light. Using it with a fan that has a light may cause damage or malfunction.

• Who should perform the wiring installation?
  All wiring must be done by a licensed electrician to ensure safety and warranty compliance.

IMPORTANT SAFEGUARDS

1. This controller is suited to NO LIGHT select Fanco fans only.
2. All wiring must be done by a licenced electrician as on-site warranty may be voided if proof cannot be provided. This ceiling fan MUST be installed by a Qualified Electrical Contractor in accordance with the local regulations, and all local, state and national electrical codes. Any alterations oradditions to building wiring must be completed by a licensed electrical contractor, or person authorised by legislation to work on the fixed wiring of any electrical installation.
3. The DC Wall Control and Fan, must be connected to a 240V AC 50Hz power supply.
4. All electrical work must only be undertaken after disconnection of the power by removing fuses or turning off the circuit breaker, to ensure all pole isolation of the electrical supply.
5. The DC Wall Control must be earthed.
6. This appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they DO NOT play with the appliance.
7. An all-pole disconnection incorporated in the fixed wiring is to be provided, such as an all-pole switch or a supply cord fitted with a plug.
8. The remote/receiver included is intended to be used with this fan and is not compatible with any other lighting and/or any other electrical device. Use of it in any way other than intended may result in damage to the fan, receiver and/or other devices and as such, will void warranty.
9. Reasonable ‘wear and tear’ is not covered under warranty. For comprehensive warranty terms & conditions visit fanco.com.au.
   IMPORTANT NOTE:
   The important safeguards and instructions given in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care are factors which cannot be built into any product.

FUNCTIONS OF THE WALL CONTROL

1. Fan Speed Higher/ON
   Toggle the dial to the right (clockwise), to turn the fan ON and to increase the fan speed

2. Fan Speed Lower/OFF
   Toggle the dial to the left (anti-clockwise), to lower the fan speed. Keep toggling left To turn the fan OFF

3. Fan Speed Indicator
   Blank = FAN OFF

   • 1 Bar = Speed 1
   • 3 Bar = Speed 3
   • 4 Bar = Speed 4
   • 5 Bar = Speed 5
   • 6 Bar = Speed 6

4. Fan ON/OFF

5. Forward/Reverse Mode

6. Hold for 3 seconds to change.

7. Forward (anti-clockwise) = Summer

8. Reverse (clockwise) = Winter

WIRING DIAGRAM – WALL CONTROL

References

• Fanco Australia | Ceiling Fan Exhaust Fan Specialist
• Fanco Australia | Ceiling Fan Exhaust Fan Specialist

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>