Kanen P2 Bluetooth Headphones User Manual
- June 17, 2024
- KANEN
Table of Contents
P2 Bluetooth Headphones
User Manual
USER GUIDE
bluetooth headphones
IN THE
BOX
POWER ON
CONNECT
VOICE PROMPTS
Power ON
Pairing
Connected
Battery Full: 100%-80%
Battery Medium: 70%-30%
Low Battery: less than 20%
Power on and automatically enter pairing mode
- To enter pairing mode again, power off and then hold PowerButton for 5 seconds
Control
| | Press once to increase volume
---|---|---
| Press and hold to skip forward
| | Press once to decrease volume
| Press and hold to skip back
| | Press once to play, pause, or answer, end a phone call
| Press twice to activate Siri or other voice control software
| Press and hold to power ON or OFF
| Press and hold 2s to reject incoming calls
Noise Cancel
| ANC ON blocks out external sounds
---|---
| Transparency lets in external sounds
| ANC OFF turn off noise cancellation and transparency
| LOW LATENCY ON real-time audio sync while gaming or watching video
Multi-point connection maximum 2 devices
1. Once FIRST device is connected, turn off Bluetooth in device settings.Headphone will auto enter Bluetooth Pairing.| 2. Enter your SECOND device Bluetooth settings and connect to headphone| 3. Enter your FIRST device settings. Turn on Bluetooth and reconnect to headphone
Charging
FACTORY RESET
Please make sure you forget “P2” from your Bluetooth device settings before resetting
1. When Power is off, press and hold the power button or 5seconds until the light flashes blue and red| 2. Keep holding +/- buttons simultaneously for 10seconds until you see the red light flashing 3times. Headphone power OFF automatically
Please read this manual carefully before use.
Safety warnings
Do not place any naked flame sources , such as lighted candles
Dispose of batteries responsibly and be aware of the environmental effects of
battery disposal Do not expose the batteries (batteries installed) to
excessive heat, such as fire or the like
Warning
To prevent possible hearing damage, do not listen at high volume levels for
long periods. For your own safety, please be aware of your surroundings when
using these headphones.
2007-2024 Kanen Electronics Company Ltd. All rights reserved.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
IC Warning
This device complies with Industry Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not
cause interference, and (2) This device must accept any interference,
including interference that may cause undesired operation of the device. The
digital apparatus complies with Canadian CAN ICES‐003 (B)/NMB‐3(B).
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be usedin portable exposure condition without restriction.
This equipment should be installed and operated with minimum distance 0cm
between the radiator & your body.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>