RADA A-TC01 AI Tracking Camera Installation Guide
- June 4, 2024
- RADA
Table of Contents
RADA A-TC01 AI Tracking Camera
CONNECTION DIAGRAM
- USB 3.0 Out (Panorama Lens)
- HDMI Out (Panorama Lens)
- LAN Port (Panorama Lens)
- USB 3.0 (Close-Up Lens)
- HDMI Out (Close-Up Lens)
- RS-232 Control Port
- Audio In
- LAN Port (Close-Up Lens)
- Power Supply (DC12V)
SETUP STEPS
-
Camera’s default IP address is: 192.168.5.191 (Tracking) / 192.168.5.192 (Wide-angle).
To change it, access the camera’s IP address via a web browser. -
Camera’s video parameters can be changed via its web interface.
-
Tracking settings are changed via IVESmart tool. It can be downloaded from our website in FIRMWARE & APPLICATIONS or scan the code to access the page directly.
To configure, follow the steps below:
- Press “Stop” to stop tracking.
- Press “Config”, set “Panoramic” and “Platform presets.
- Define “Platform”, “Tracking” and “Mask” areas.
- Adjust tracking parameters.
- Press”Save Param.” and start tracking.
To download User Manual please visit www.a-dena.com and go to TECHNICAL INFORMATION under RESOURCES
PACKAGE CONTENT
A-TC01 Al Tracking Camera
Remote Controller
Power Adapter
USB Type A to Type A 3.0 Cable
RS-232 D89 Female to 8 Pin Din Cable Quick Installation Guide
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>