KENWOOD JKP210 Series Electric Kettle User Manual

KENWOOD JKP210 Series Electric Kettle

Kenwood Ltd

• New Lane
• Havant
• Hampshire
• PO9 2NH
• kenwoodworld.com
  • Copyright 2022 Kenwood Limited. All rights reserved

safety

• Read these instructions carefully and retain for future reference.
• Remove all packaging and any labels.
• If the plug or cord is damaged it must, for safety reasons, be replaced by Kenwood or an authorised Kenwood repairer in order to avoid a hazard.
• Always use the filter and never overfill – boiling water may splash out.
• Avoid contact with steam coming out of the spout area when pouring and out of the lid or spout area when refilling.
• Never let the cord hang down where a child could grab it.
• Always unplug your kettle when not in use.
• Never put the kettle, powerbase, cord or plug in liquid.
• Never use a damaged appliance. Get it checked or repaired: see ‘service and customer care’.
• Caution: Do not operate the kettle on an inclined surface.
• Only use the powerbase supplied and keep it clean and dry.
• Make sure the lid is secure before switching the kettle on.
• Warning: Do not open the lid while the water is boiling.
• Take care when opening the lid – droplets of hot water may be ejected.
• Make sure the kettle is switched off before lifting or pouring.
• Remove the kettle from the base before filling or pouring.
• Never put the kettle near or on cooker hot plates or gas burners.
• This kettle is for boiling water only.
• Misuse of your appliance can result in injury.
• Children from 8 years and above can use, clean and perform user maintenance on this appliance by the User Instructions provided they are supervised by a person responsible for their safety and have been given instructions concerning the use of the appliance and are aware of the hazards.
• Persons with reduced physical, sensory or mental capabilities or lack of knowledge using this appliance must have been given supervision or instruction on its safe use and are aware of the hazards.
• Children must not play with the appliance and both appliance and cord must be out of reach of children less than 8 years.
• The heating element surface is subject to residual heat after use
• WARNING: Be careful to avoid any spillage on the connector, during cleaning, filling or pouring.
• Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

• Make sure your electricity supply is the same as the one shown on the underside of your kettle.

Important – Plug and Fuse Information

• The wires in the cord are coloured as follows:
  • Green and Yellow =
  • Earth Blue = Neutral
  • Brown = Live.
• The appliance must be protected by a 13A approved (BS1362) fuse.
• If the plug supplied with your appliance has a fuse fitted and the fuse fails it must be replaced with one of the same rating.
• If the plug or cord requires replacing a new cord set should be fitted by an Authorised Kenwood Repairer.
• WARNING: THIS APPLIANCE MUST BE EARTHED.

Note

• For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).
• If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a socket outlet.
• This appliance conforms to EC Regulation 1935/2004 on materials and articles intended to come into contact with food.

before using for the first time

1. Wrap any excess cord around the bracket on the underside of the powerbase 5.
2. Fill to ‘MAX’, boil, then pour the water away. Repeat 2 to 3 times.

key

1. flip top lid
2. lid release button
3. on/off switch with indicator light
4. 360° powerbase
5. cord wrap
6. water level windows
7. filter

to use your kettle

1. Fill the kettle through either the spout or lid. To open the lid, press the lid release button. The water level must be between ‘MAX’ and 1 cup (250mls).
   • Be economical: do not boil more water than you need.
   • To improve the quality of your drinks always use fresh water.
   • Empty the kettle after each use.
2. Check the lid is closed.
3. Plug in and switch on. The indicator light will come on.
4. Your kettle will boil and switch off automatically. To re-boil, wait a few seconds – the on/off switch needs time to reset.

Note – To interrupt the boiling ensure that the switch is in the off position before removing from the powerbase.

• If you experience problems with your kettle switching on and off during use or switching off before boiling, check that the flat element is free from scale – see “descaling”.
• Your kettle is fitted with a filter to hold back limescale particles.
• If you find drops of water under your kettle, don’t worry – it is just condensation. boil-dry protection
• If you switch on with too little water, your kettle will cut out automatically. Switch off, remove from the powerbase and let it cool down before re-filling. When it has cooled down, the switch will reset itself.

care and cleaning

• Before cleaning, unplug your kettle and let it cool down.
  the outside and powerbase

• Wipe with a damp cloth, then dry. Do not use abrasives – they will scratch the plastic surfaces.
  the inside

• Even though your kettle comes with a filter, you still need to clean the inside (and the filter) regularly.
  the filter

1. Open the lid. Press the lid release button 2.
2. Gently lift out the filter 1.
3. either rinse under the tap or use a soft brush. or when descaling your kettle, drop the filter in too. Rinse thoroughly.
4. To re-fit the filter, slide it in until secure 2.
5. Close and lock the lid by pressing the lid down 3.

descaling

• Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following:

• problems may be experienced with the kettle switching on and off during use or switching off before boiling.

• the kettle may take longer to boil.

• the flat element may be damaged.
  Please note: Failure to descale your kettle may invalidate your guarantee.

• When limescale starts to build up on the heating element, buy a suitable descaler and descale your kettle. After descaling, boil with fresh water several times and discard. Clean any descaler off the kettle – it can damage the parts.

• Some regions of the country have chalky water. This makes boiled water look cloudy and leaves a deposit on the side of the kettle. This is normal but can be removed with regular cleaning.

• Alternatively, to reduce limescale buildup, use filtered water to fill your kettle.

service and customer care

UK
If you need help with:

• using your kettle

• servicing or repairs (in or out of guarantee) Z call Kenwood Customer Care on 0345 222 0458 or visit www.kenwoodworld.com. Have your model number (e.g. JKP210 or JKP230) and date code (5-digit code e.g. 13L35) ready. They are located on the underside of your kettle and power base.

• spares and attachments Z call 0844 557 3653.
  other countries

• If you experience any problems with the operation of your appliance, before requesting assistance visit www.kenwoodworld.com.

• Please note that your product is covered by a warranty, which complies with all legal provisions concerning any existing warranty and consumer rights in the country where the product was purchased.

• If your Kenwood product malfunctions or you find any defects, please send it or bring it to an authorised KENWOOD Service Centre. To find up-to-date details of your nearest authorised KENWOOD Service centre visit www.kenwoodworld.com or the website specific to your Country.

• Designed and engineered by Kenwood in the UK.

• Made in China.
  guarantee (UK only)
  If your kettle goes wrong within one year from the date you bought it, we will repair or replace it free of charge provided:

• you have not misused, neglected or damaged it;

• it has not been modified (unless by Kenwood);

• it is not second-hand;

• it has not been used commercially;

• you have not fitted a plug incorrectly; and

• you supply your receipt to show when you bought it.

This guarantee does not affect your statutory rights.

children and burns or scalds

advice from the British Burn Association
Every year, 30,000 children go to hospital with burns. What might be a minor burn for an adult could horrifically injure – or even kill – a child. take these precautions

• Keep hot drinks out of children’s reach.
• Don’t drink while holding your baby. If you’re passing someone a drink, make sure a child isn’t underneath.
• Keep your kettle, and its cord, well back from the worktop edge so that children can’t grab them.
• Keep children away from the kitchen work area.
• For baby’s bath, run the cold water first, then add the hot. Mix well and test the temperature with your elbow before you put baby in.
• Teach children about hot things. run cold water over a burn immediately, then get medical help. Don’t stop to remove clothing.

References

• Kenwood UK | Kenwood Home page
• Kenwood UK | Kenwood Home page
• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>