Huihaikang EM9GC EM9 Wireless Ergonomic Mouse User Manual

**Huihaikang EM9GC EM9 Wireless Ergonomic Mouse User Manual

**

Product Information

1. Power On/Off
   • Slide the switch to power on/off the mouse.
2. Connect up to 3 devices via mode Switching:
   ‘

2.4G mode (red light)

Bluetooth channel 1
(flashing green light)
Bluetooth channel 2
(flashing blue light)

• Press the mode switch button on the bottom to toggle between:

  1.  **4G Mode Pairing:**
    * Enter 2.4G mode, the red light blinks.
    * Insert the receiver into USB; it auto-pairs.
    * After pairing, red light for 3 seconds, then off.
    * If not paired automatically, press left + middle + Right buttons for 3 seconds to reactivate pairing mode.
  2.  **Bluetooth Pairing:**
    * In Bluetooth mode, hold the switch button for 3 seconds until quick flashing.  

    * Go to the BT settings of your device and find or “EM9 BT5.0 ” to pair and connect. EM9 BT3.0 EM9 BT5.0 Input  

“EM9 BT3.0”

Input
EM9 BT5.0

Input

    * If the connection was built up, the BT indicator light will automatically turn off.
    * If not paired automatically, press the pairing buttons for 3 seconds to reactivate pairing mode.
  3.  **OPI (Dots Per Inch)  

**

Change DPI with a press of the DPI cycle button.

    * Factory DPI settings:
  4.  **Battery and Sleep:**
    * Red battery indicator light flashes means low power. Insert into USB for charging (Light on means charging. Light off when fully charged.)
    * Moving the mouse wakes it up from Level 1 sleep mode (inactive for 5s to 1 min) or Level 2 sleep mode (inactive for 1 min to 30 mins). Pressing a key wakes the mouse up from Level 3 sleep mode (inactive for more than 30 mins).

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ‐‐ Reorient or relocate the receiving antenna.

•  Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.ct. The device has been evaluated to meet general RF exposure requirement.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>