KitchenAid KSSC36FM Side By Side Built In Refrigerator User Guide
- June 16, 2024
- KitchenAid
Table of Contents
KSSC36FM Side By Side-Built In Refrigerator
Product Specifications
- Model Numbers: KSSC36FM, KSSC36QM, KSSC42FM, KSSC42QM, KSSC48FM, KSSC48QM, KSSO36FM, KSSO36QM, KSSO42FM, KSSO42QM, KSSO48FM, KSSO48QM, KSSP36QM, KSSP42QM, KSSP48QM, KSSS36FM, KSSS36QM, KSSS42FM, KSSS42QM, KSSS48FM, KSSS48QM, KSSV42FM
- Electrical: 115-volt, 60-Hz, AC-only, 15- or 20-ampere
- Cold Water Supply: Water pressure between 20 and 120 psi (138 – 827 kPa)
- Cabinet Opening Dimensions: Width A (Trim edge to trim edge) – 36 in. (91 cm), 42 in. (106 cm), 48 in. (122 cm)
- Overall Dimensions: Width A – 35 in. (89 cm), 41 in. (104 cm),
- 47 in. (119 cm)
Product Usage Instructions
Electrical Connection
A 115-volt, 60-Hz, AC-only, 15- or 20-ampere, fused electrical supply is required for the product. It is recommended to use a time-delay fuse or circuit breaker. Make sure to provide a separate circuit serving only this appliance. It is recommended that a separate circuit serving only this appliance be provided.
Cold Water Supply Connection
Connect the ice maker to a cold water line with water pressure between 20 and 120 psi (138 – 827 kPa). If you are unsure about your water pressure, contact your utility company for assistance.
Cabinet Opening Dimensions
The cabinet opening dimensions vary based on the model. Please refer to the chart provided in the user manual for the specific dimensions of your model.
Overall Dimensions
The overall dimensions of the product also vary based on the model. Please refer to the chart provided in the user manual for the specific dimensions of your model.
WATER SUPPLY REQUIREMENTS
If the water shutoff valve is located in the base cabinet, the access hole through the side of the cabinet must be within 1/2″ (12.7 mm) of the rear wall. The right side cabinet is recommended. If the water shutoff valve is not in the cabinets, the water line can come through the rear wall or floor in the shaded area dimensioned above.
ANTI-TIP REQUIREMENTS
- A. Center board 1/4 in. (6 mm) max. above refrigerator
- B. Two, 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) boards
- C. Attach to studs with 6 -#8 x 3 in. (7.6 cm) screws
- D. Compressor cover
The solid soffit must be within 1 in. (2.5 cm) maximum above the refrigerator.
If the solid soffit is higher than 1 in. (2.5 cm) or one is not available,
prevent the refrigerator from tipping during use as shown.
Board(s) must be long enough to fully cover the width of the compressor cover.
Locate the board(s) so the bottom surface of the board(s) are 84 in. (213 cm)
from the floor.
Securely attach one or two 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) wood
boards to wall studs behind refrigerator. Use 6 -#8 x 3 in. (7.6 mm) (or
longer) wood screws. The wood screws must be screwed into the studs at least
1-1/2 in. (3.8 cm). The board(s) must overlap the compressor cover.
DOOR SWING DIMENSIONS
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
FAQ
Q: Can I use a higher ampere electrical supply?
A: No, it is recommended to use a 115-volt, 60-Hz, AC-only, 15- or 20-ampere electrical supply as stated in the specifications.
Q: Can I connect the ice maker to a hot water line?
A: No, it is recommended to connect the ice maker to a cold water line with water pressure between 20 and 120 psi (138 – 827 kPa).
Q: How do I determine the cabinet opening dimensions for my model?
A: Refer to the chart provided in the user manual for the specific cabinet opening dimensions of your model.
Q: Are the overall dimensions the same for all models?
A: No, the overall dimensions vary based on the model. Refer to the chart provided in the user manual for the specific overall dimensions of your model.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>