KitchenAid KSSO48QM Side by Side Built In Refrigerator Instruction Manual

June 16, 2024
KitchenAid

**KitchenAid KSSO48QM Side by Side Built In Refrigerator Instruction Manual

**

PRODUCT MODEL NUMBERS

KSSC36FM
KSSC36QM
KSSC42FM
KSSC42QM
KSSC48FM
KSSC48QM
KSSO36FM
KSSO36QM
KSSO42FM
KSSO42QM
KSSO48FM
KSSO48QM
KSSP36QM
KSSP42QM
KSSP48QM
KSSS36FM
KSSS36QM
KSSS42FM
KSSS42QM
KSSS48FM
KSSS48QM
KSSV42FM

Electrical: A 115-volt, 60-Hz, AC-only, 15- or 20-ampere, fused, electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.
Cold Water Supply: Connect the ice maker to a cold water line with water pressure between 20  and 120 psi (138 – 827 kPa). If you have questions about your water pressure, call your utility company).

OVERALL DIMENSIONS

Front view

Other model series dispensing, and non-dispensing, with different styling are available.

CABINET OPENING DIMENSIONS

WATER SUPPLY REQUIREMENTS

If water shutoff valve is located in base cabinet, access hole through side of cabinet must be within 1/2″ (12.7 mm) of rear wall. Right side cabinet is recommended. If water shutoff valve is not in cabinets, water line can come through rear wall or floor in shaded area dimensioned above.

ANTI-TIP REQUIREMENTS

A. Center board 1/4 in. (6 mm) max. above refrigerator
B. Two, 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) boards
C. Attach to studs with 6 -#8 x 3 in. (7.6 cm) screws
D. Compressor cover

The solid soffit must be within 1 in. (2.5 cm) maximum above
the refrigerator. If the solid soffit is higher than 1 in. (2.5 cm) or
one is not available, prevent the refrigerator from tipping during
use as shown.
Board(s) must be long enough to fully cover the width of the compressor cover. Locate the board(s) so the bottom surface of the board(s) are 84 in. (213 cm) from the floor. Securely attach one or two 2 in. x 4 in. x 32 in. (5 cm x 10 cm x 81 cm) wood boards to wall studs behind refrigerator. Use 6 -b  #8 x 3 in. (7.6 mm) (or longer) wood screws. The wood screws must be screwed into the studs at least 1-1/2 in. (3.8 cm). The board(s) must overlap the compressor cover.

DOOR SWING DIMENSIONS

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.

Ref. 2266811 09-10-04

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

KitchenAid User Manuals

Related Manuals