KICKER TW2 Wireless Earbuds Owner’s Manual

: June 16, 2024
: KICKER

Table of Contents

Connections
Charging
Controls
Pairing
LEDs
Fitment
Specifications
Troubleshooting
WARRANTY
FCC CAUTION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KICKER TW2 Wireless Earbuds Owner’s Manual

Connections

Charging

Fully charge the TW Cradle and Earphones before first use by connecting to power supply for up to 2.5 hours. The Charging Cradle will supply over 2 full earphone charges.

Controls

Power On/Off

The TW-series earphones will power on automatically when removed from the Charging Cradle. If the earphones are off due to auto-timeout (5 minutes), you can also press and hold the Touch Sensor for 3 seconds to turn them back on. To turn off the earphones, return them to the Charging Cradle.

Audio:
PLAY/PAUSE
Double-tap the Touch Sensor of the left or right earphone to play or pause your audio .
PREVIOUS TRACK/NEXT TRACK
Press and hold the left earphone for 2 seconds to go to the previous track. Press and hold the right earphone for 2 seconds to go to the next track.

Phone:
Answer/Hang-up
Double-tap the left or right earphone to answer an incoming phone call, or to hang-up.
Reject Incoming Call
Press and hold the left or right earphone for 2 seconds to reject an incoming call.
Voice Assistant
Triple-tap the left or right earphone to activate your phone’s voice assistant feature.

Reset: Must be in Pairing Mode – turn off your audio device’s Bluetooth when performing.
TW1
Press and hold the left or right earphone for 6 seconds.
TW2
Tap the left or right earphone 6x in 1.5 seconds.

Pairing

Remove the TW from the Charging Cradle.
Begin searching for Bluetooth devices from your audio source.
Select “TWS KICKER” to pair.

LEDs

Cradle LED
Fast Red Blink: Cradle Charging
Solid White: Fully Charged

Earphone LED
White Blink : Pairing Mode
Red Blink : Low Battery

Cradle LED
Red Blink: Cradle Charging
Solid Red : Fully Charged
White Blink: Cradle Battery Low
White: Earphone Charging
Off: Earphone Fully Charged

Fitment

Insert earphone, and gently turn while pushing. If fitment is unsatisfactory, please try a different ear tip (TW2)

WARNING
Exposure to excessive sound levels can cause permanent hearing damage. Keep out of reach of children. The content of this package includes small parts and cords that can cause choking or strangulation. If an earphone or earphone tip becomes lodged in the ear canal, seek professional medical assistance for its removal. Never pull on the cord to remove the earphones. Use a low twisting motion to remove from ear.

Specifications

Troubleshooting

TW is unresponsive or will not power on:

Check that the battery is fully charged by connecting the TW Charging Cradle to a known-good power source with the TW earphones inside. Allow the TW to charge for at least 2.5 hours with the cradle lid closed. The earphone battery is full when the battery status LED turns off (TW2 only).
Reset the TW1 by pressing and holding the touch sensor for 6 seconds. Reset the TW2 by tapping the touch sensor 6x in 1.5 seconds.

TW will not pair or connect:

If you have previously paired your device with the TW, then please ‘Unpair’ or ‘Forget this Device’ per the instructions for your audio device.
Turn on the TW earphones with your audio device in Bluetooth Scanning mode. Make sure your audio device is scanning or in ‘discovery mode’, then select TWS KICKER.

Device paired and connected, but volume is low or inaudible:
Check the volume output level of your audio device.

WARNING!
Keep out of reach of children. The content of this package includes small parts and cords that can cause choking or strangulation.

WARRANTY

KICKER products are warranted against defects. Duration and terms of warranty depend on the laws in the country in which it was purchased. For details see your local KICKER Dealer or www.kicker.com/warranty.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

FCC CAUTION

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE

FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR
COMPLIANCE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS
B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED
TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL
INSTALLATION. THIS EQUIPMENT GENERATES USES AND CAN RADIATE RADIO FREQUENCY ENERGY
AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE
HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE

INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES:

REORIENT OR RELOCATE THE RECEIVING ANTENNA.
INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED.
CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.

RF WARNING FOR MOBILE DEVICE:
THIS EQUIPMENT COMPLIES WITH FCC RADIATION EXPOSURE LIMITS SET FORTH FOR AN UNCONTROLLED ENVIRONMENT. THIS EQUIPMENT SHOULD BE INSTALLED AND OPERATED WITH MINIMUM DISTANCE 20CM BETWEEN THE RADIATOR & YOUR BODY.
Company logo