WalkingPad WPA1F Walking Device User Manual

WalkingPad WPA1F Walking Device

Caution : The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Welcome to use

Thank you for choosing WalkingPad Walking Device , hereinafter referred to as a WalkingPad, which posess various advantages including exquisite, simple, innovative integral design. From now on, enjoy the quality life of walking at home.

56.5″ｘ21.5″ｘ5″

Folding dimensions| 822×547×129mm/

32.5″ｘ21.5″ｘ5″

The area of Walking belt| 1200×415mm/

47″ｘ16.5″

Gross weight| 68 Ibs / 31kg
Net weight| 62 lbs / 28kg
Maximum load| 220 lbs / 100kg
Applicable age| 12-60 years old
Applicable height| Unlimited
Minimum speed| 0.5 mi/hr 0.5 km/hr
Maximum speed| 3.75 mi/hr 6 km/hr
Power Input| 746W
Rated voltage| 110-120V~
Sport mode| Standby mode /

Fixed mode /Automatic mode

Product and Accessories

Please carefully check whether the contents of the package are complete and intact. If there is any missing or damaged, please contact the seller.

Function schematic diagram

Product main body

Introduction of the function of the indicator panel

Walkingpad remote control

Guide for initial operation

1. Choose flat ground to place the walkingpad. It is forbidden to place it on a thick and soft cushion.
2. Unfold the walkingpad slowly and press it down to completely flat.
3. Check and adiust the walking belt in the middle position.
4. Connect the power line and turn on the switch.
5. Search “Walkingpad” App from Apple Store or Android Google Play and complete installation.
6. Open the App, follow the prompts to set up the device.
7. Enter novice guide.
8. Complete learning to get all functions, Otherwise, the Speed Limit is 1.75mi/hr, 3.75mi/hr can be unlocked after novice guide.
9. Start to use the walker.
10. If the belt deviates from the orbit in use, please adjust properly.
    SEE: 06 Maintenance and servicing.

Learn to use WalkingPad

Mode instruction

Standby Mode
Light of the Standby mode is on;
Motor and sensor stop response.

Fixed speed mode
Light of the fixed speed mode is on; Control the speed through the remote control or APP.

Automatic Mode
Light of the automatic mode is on;
Speed is automatically controlled by intelligent algorithm.

Instructions of the standby mode control.
The motor and sensor stop responding in this mode to prevent nonusers from accidentally triggering the WalkingPad.

Instructions of fixed speed mode control (primary mode)
In this mode, the speed of the Walki ngPad can be controlled by the remote control. It is recommended that beginners use the fixed speed mode first and then us e the automatic mode after being skilled in using th e WalkingPad.The fixed speed mode is controlled by remote control by default, that is, the S TART/STOP button of the remote control i s used to start or stop the WalkingPad, which can be modified in the cl ient “Personalized”.

Description of automatic mode control (advanced mode)

Remote Controller Notice

If the remote controller has no response or you change a new one, The remote controll er and walking device need to re-establishing communication.

Pairing method: Restart walking device and short press the MODE Button of Controller many times during display “WAIT”.

Fault Waming Linght

The Fault Warning Light i s off when the walking machine is working well. While error occurs, the fault warning light is on and the display panel shows the error code

E01：Drive communication fault
E02：Motor abnormalities
E05：Overcurrent protection
E06：Motor Protection
E08：Sensor Fault
E10: High temperature protection, automatic recovery after the end of countdown.
E11: Overload protection, please add lubricating oil, and resume automatically after countdown.

Safety Notice

Maintenance and servicing

Clean the walking machine

• Unplug the unit from the electrical source before you begin.
• Pour a little gentle detergent in the cotton rag or towel. Don’t pour the detergent on the belt directly, and don’t use acid or corrosive cleaners.
• Wipe down the frame, motor encasement and belt. Don’t wipe backside of the belt.
• After a period of using, the end part may appear dust and stains, that’s normal situation, and just clean up.

Adjust the belt

• Pressing both Mode Button and Acceleration Button on the remote controller over 3 seconds.
• The display panel shows “CALI” and the speed is 2.5mi/hr(4km/h).
• If belt moves left: Turn the left adjusting screw a half-circle clockwise.
• If belt moves right: Turn the right adjusting screw a half-circle clockwise.
• If belt is slipping: Turn both left and right adjusting screw a half-circle clockwise at same time.
• Check whether need to readjust after use 1 to 2 minutes.

Lubricate the Belt

• Unplug the unit from the electrical source before you begin.
• Lift up the belt and apply the silicone to the underside surface of the belt. Power on the walking machine.
• Make the machine running with 2.5mi/hr(4km/h) 10 to 20 seconds.
• No more 5 to 10ml lubricant, too much will make the belt slipping.
• Silicone oil once every 3 months.

Hazardous substances declaration

Part Name

| The table of Hazardous Substances
---|---
Lead

(Pb)

| Mercury

(Hg)

| Cadmium

(Cd)

|

Hexavalent Chromium

(Cr(VI))

|

Polybrominated Biphenyls

(PBB)

|

Polybrominated diphenyl ethers

(PBDE)

Electronic

Components

| X| 〇| 〇| 〇| 〇| 〇
Metal Parts| 〇| 〇| 〇| 〇| 〇| 〇
Shell| 〇| 〇| 〇| 〇| 〇| 〇
Battery| 〇| 〇| 〇| 〇| 〇| 〇
Other Parts| 〇| 〇| 〇| 〇| 〇| 〇
This form has been prepared in compliance with the provisions of SJ/T 11364.

〇: Indicates that the content of said hazardous substance in all of the homogenous materials in the component is within the limits required by GB/T 26572.

X: Indicates that the content of said hazardous substance exceeds the limits required by GB/T 26572 in at least one homogenous material in the component.

Trademark and Legal Declaration

Beijing Kingsmith Technology Co., Ltd has patents of WalkingPad Walking Machine series products.
This manual is created by Kingsmith and owns the copyright. Any form of unauthorized distribution, reproduction, publication, release or quotation by any institution or individual is prohibited without Kingsmith’s written permission, not allow using the patents.

This manual contains as much as possible functions and instructions for use when it is printed. However, due to product imperfections, design changes, etc., may still have discrepancies with the product you purchased. In view of product updates, this manual and the actual product may vary in color, appearance, etc., actual supplies prevail.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Manufacturer : Beijing Kingsmith Technology Co., Ltd
Address : Floor 4, Building 25, Area 18, ABP Park, Fengtai, Beijing, China.
Product performance standard: Q/FTSMS0001-2017

References

• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>