LinkedSparx LS-T3 The Box LED Christmas Strip Lights User Guide
- June 9, 2024
- LinkedSparx
Table of Contents
LinkedSparx LS-T3 The Box LED Christmas Strip Lights
What’s in the Box?
- The power adapter is NOT included in the kit. You can use a standard 5V USB charger or a power bank. An output of 5V Hook & Loop 1~2A is recommended.
The Box Modules
Module Dimensions
a
|
5.6cm / 2.2in
b
|
5.6cm / 2.2in
c|
2.4cm / 0.94in
- Color: RGB 16 million colors
- Connectivity: BT
- Working Voltage: 5V/2A
- Max Panels Per PSU ≈ 100
- Max Panels Per Controller on a route: 300
- Materials: Fireproof Polycarbonate & ABS
- Operating Temperature: -5~45°C
- Life Span: More than 20,000 hours
Controller
RF Remote
App Download
Please scan the QR code to download the ‘LEDSMART’ App
| 
---|---
|
*This application requires iOS 10.0 or later / Android 4.4 or later.
- Download and install the “LEDSMART” App.
- Go to ‘Settings’ of your mobile device and turn on BT.
- App automatically searches and lists all available SYRO devices nearby. Select your device to connect, then you can fully control The Box.
-
Generally, you can control up to 5 devices simultaneously.
This may vary from different phones.
-
The user interfaces provided above are for reference only, and might be different from the latest version of the App.
Online Guide
For more detailed features about the App, please visit www.linkedsparx.com /syro-app
MUST READ Before Installation
To accurately perform all light effects on your layout, our App lets you decide the sequence number of modules you wish to control or multiply
How to count the sequence number of light modules
If you connect 2 or 3 modules to the previous module, these newly connected
(next-tier) modules will receive the same command from the previous one,
therefore display same and synchronized effect.
You need to count the number of modules connected in the longest line.
As you can see from the example below, you should set the sequence number as
4.
The sequence number you set should either be the same or less than the number
of all connected modules.
How to multiply light effect
It is also possible to set a small number than your actual setup. The App can
automatically duplicate effects for the following segments.
For example, if you have 10 modules connected in a line and and set the number
as 5, the 2 segments of modules will play the same effect.
Each module has 1 input and 3 outputs. You can easily find the input with an arrow mark on it.
Please always plug the power + signal incoming source into the input. Be aware
that improper connections could cause malfunction, such as modules not
lighting up or uncontrollable.
How to Create Your Own The Box Layout
Firstly create your layout on a flat surface and designate a module as the
starting module.
When you are satisfied with your layout, attach connectors between modules.
*There are 50 connectors in the kit.
Then use a Type-C cable to connect the controller to the starting module.
All modules lighting up indicates a correct connection.
If no modules light up, please check if the controller and the power adapter
are connected properly.
If certain modules DO NOT light up, please make sure you connect the input and
output between modules correctly
A power supply with 5V 2A output can carry 50 modules.
If you wish to connect more than 50 modules, you can plug a charger or power
bank with a Type-C port into any output port of a module to provide extra
power supply.
Theoretically speaking, you may extend your layout to up to 300 modules in a
single line with enough power supply
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>