WINY V300HD HD Smart Black Box Car Drive Recorder User Manual

: June 16, 2024
: WINY

WINY V300HD HD Smart Black Box Car Drive Recorder

Precautions for safety when using the product

Please do not operate the product while driving. It may cause accidents.
Please install the product in a place not to interfere with a driver’s view.
Do not disassemble or convert the product intentionally. It may lead to product failure and the responsibility for the damage to the product resulting from this shall be borne by the user.
When damage to the product itself occurs due to a major accident or the power is disconnected, images of the accident may not be recorded.
Please keep the windshield clean at portion of recording before recording.
Since this product is a device that records a driving video by using the camera, the image quality may drop when entering the tunnel, in shading contrast, backlight and photometric conditions, and in the middle of the night.
In case those foreign objects attach to the camera lens, the recorded video may not be in good condition. Please keep the lens clean.
Do not leave a product in a place exposed to direct sunlight in a car or a confined car. It may cause a malfunction.
Do not wipe the product using chemicals, detergents, etc., but wipe it lightly using a soft cloth.
The thermal environment at below -5℃ or over 55℃ may cause a malfunction or failure of the product. (When not using the product, please be careful about storage temperature)
Do not use the product in a place at high temperature or much moisture.
Do not press excessive force on the products (especially buttons and brackets). It may cause a malfunction of the products.
Before using the product, make sure to operate it for 3 to 5 minutes verify that the image saved properly and then use it.
If the product is in prolonged exposure to sunlight or high temperatures during the summer, normal operation can be difficult.
When a firmware upgrade is in progress, if the SD card is removed or power is disconnected, failure of the product may occur, so should be careful.
When removing or disconnecting the cigarette lighter cable, it may result in electric shock, so do not touch it with wet hands.
Do not use the damaged cigarette lighter cable. It may cause fire and electrical shock.
Do not leave the cigarette lighter cable or the product near the heating equipment.
When not using the product for the long term, please separate the cigarette lighter cable from the product.
Please plug the cigarette lighter cable correctly and should not be shaken.
Do not bend or pull the cigarette lighter cable forcefully or avoid placing heavy objects on the cigarette lighter cable. (A damaged power cord may cause fire or electric shock)
Even if the overwrite function is in the ‘Off’ condition, a part of the recorded file may be deleted to create some recording space at booting.
In the lower frame setup, the event may not be recorded. For the stable event recording, a recording setup greater than or equal to 15 frames is recommended.

Precautions when using an SD card

To confirm the normal operation of the product, please check the image of an SD card and format it regularly. (PC format needed one to two times per month)
Because an SD card is consumable, if it is used for a long time, you may lose the data or may not record due to an error, so please check it periodically.
When the product is in recording or the power is on, do not eject the SD card forcibly. It may cause a failure of the SD card and data loss.
Due to excessive temperature rise inside the car, the data may not be saved or get damaged, so please park the car in a cool place in the summer.
When identifying the car’s accident or damage, please keep the SD card separately. Due to overwrite, important data may be deleted.
When tturningoff the power of the body and removing the SD card before the LED is turned off, the last recording file may not be saved, so please be careful.
In general, the SD card is a consumable product in life, so if it is not used for a long time, you may not be able to save the data. In this case, buy a new SD card and use it, and please always check that the recorded images and an SD card have no problems with data storage.
When driving a car, do not remove the SD card. Make sure to remove it safely when a car is in parking or stopping.
After turning on the power, make sure that it is in normal operation.
Please note that the warranty period of an SD card is six months, and replace it at the time of more than six months.
The SD card randomly purchased other than the one we provide, shall be excluded from the warranty, and we shall not take any responsibility for loss and damage of the data recorded in the SD card in any case.
After checking the playback recorded video on a Smartphone (support Android only), remove the SD Card and follow below. Menu → Configuration → System → Mode change space → SD Card un-mounting (if you do not “SD Card un-mounting“, SD Card might be damaged.)

This product is an assistant device for recording driving video. Please use this product for your reference for checking driving video, not as special CCTV because the image might not be recodependingend on the environment.
This product might change without any notice for performance improvement.
This user manual indicates only the basic user manual, please check furthermore detailed information from http://winycam-eng.com

Precautions when using a Battery

Please follow the below otherwise Heat generation, Fire, Explosion, etc might happen.

Contact the manufacturer or distributor if the battery bellowed up even by the naked eye.
Use only packaged batteries and do not modify and disassemble.
Never put this built-in battery product close to fire.
Do not leave the product for a long time inside the car in summer.
Use Warranted lithium polymer portable charger by manufacture.
Do not disassemble, crimp, or destroy.
Do not drop from a high location and give a shock to the product.
Do not leave the product in a location that is over 60˚C.
Do not leave a product in a humid location.

Battery Disposal Instructions

Do not throw away a used battery.
When disposing of a battery, do not burn it and put it in a fire. (Due to heat, it may cause an explosion or fire.)
Battery disposal may vary by country and region. (Please dispose of it properly).

Package

The viewer program is stored in a Micro SD card. Please use it after saving the program in advance on the computer, etc. so that the program can’t be deleted. (If it is deleted, you can download it from our website.) The packaged product picture of the user manual may differ from the actual product. The video cable is used for connection to the TV/carr navigation, and can monitor real-time. But please note that depending on the monitor, the Video input type is different and check the user manual of the monitor.

Product Features

2 Mega Pixel image sensor mounting.
150 degrees (based on the lens) wide mega lens (based on actual recorded video) is applied.
HD (1280X720) resolution and 30FPS are supported.
Security LED lights are mounted on the front body (LED Lighting function On/Off can be set in PC viewer)
Car constant power discharge protection function (setup is available in PC viewer) is built-in. Separated power discharge safety equipment is not necessary.
G sensor built-in Automatic parking recording mode change and event recording mode.
Various recording functions – normal, manual, event, motion, automatic parking recording mode change.
Operating instructions service by voice guidance.
External video output. (real-time video image can be checked)
Soft look and emotional design. (easy removable body)
Driving records can be stored with GPS data. (optional)
PC viewer software is provided to change various setting values and map data can be checked when using GPS. (In the general video player (e.g. Windows media player), recorded video can be played)
High-performance microphone built-in
Back-up battery built-in (safety backup power support)
Memory backup is available by flash memory, even if the error occurs when firmware is in upgrade.
When the car’s constant power discharge functions in setup, the dark current of less than 2mA is consumed. (based on 12V)
SD card can be formatted as the product itself, without connecting to a PC.
When using car constant power discharge protection functions, If user’s car voltage is 12V and the voltage of less than 11.8V is maintained for more than 30 seconds the product power will be shut off. In case the user’s car is 24V, power will be shut down after 30 minutes with less than 24V.
(Note: Shutdown time depends on the Type of Car and car condition.)
Voice recording On/Off function and speaker output On/Off function.
Each capacity of the normal/ event/ motion folder can be set in PC Viewer.
Recording image resolution can be set to change. (HD/D1/VGA)

Function

How to Install

Insert the Micro SD card into the product. (Note the direction of the SD terminal)
Connect the packaged cigar adapter to the power connecting terminal.
Remove the protective sticker on the double-sided tape of the bracket.
Clean foreign substances in a place to attach the product first and attach the product.
Connect the cigar jack to the car cigar socket.
The picture after the installed

How to record

Recording: V300HD is automatically booted at power on, and recording starts in basic normal recording mode.
Recording Mode: it is classified into driving recording mode and parking (motion) recording mode
Recording Method: it is classified into normal recording, event recording, and motion recording.
- For automatic recording and manual recording methods, please refer to the below table.
- after changing to the parking recording mode manually, if you want to change to normal recording mode again, please press the “REC” button for 3 seconds (during event recording, the mode cannot be changed.)
- Even if power is interrupted during event recording mode, 30 seconds can be recorded completely before power is off. (Only if built-in battery is fully charged)
- If an event (G-sensor detection and manual recording by button control) occurs during motion recording mode,
- After the motion recording mode is completed, the motion recording file will be changed into event recording files, and the event recording mode will start immediately.

LED Operation Guide

When no GPS signal or depends on the GPS signal receiving location and signal condition, LED displays only lightning.

Voice Guide

How to Install the Original Viewer Program

System Requirements
- Windows XP(32bit), Windows Vista(32bit), Window7(32/64)
- Pentium 4 2.8GHz & RAM 1GB .
- 1024 * 768 Display device is set to be the primary monitor.
- DirectX Support (WPF)
Install
- The playback program is on a packaged SD card.
- Insert this SD card into the USB card reader and connect to the computer.
- An executable file is in the SD card as below figure.
- If you run “setup.exe”, Winy BB Viewer will be installed. Then, the installation will be continued according to the installation sequence of the setup dialogue box.

Original Viewer Screen Configuration

Original Viewer – Playback

Recorded images can be played back in the Windows Media Player in addition to the original viewer. (When checking GPS information, please use the original viewer only)

Original Viewer – GPS

Original Viewer – Zoom

Expand your entire playback screen

Double-click on the playback screen.
A new playback screen will be opened.
The size of the playback screen will be able to be tripled.
- Note: The expanded entire playback screen can not be printed out.

Expand part of your playback screen

Pause the screen.
Click “Zoom” on the header.
Drag from top left to bottom right of the particular area.
The expanded screen will be opened and the size of this screen able to be quadrupled.

Original Viewer – Configuration

Connect SD card to a computer, and then specify the configuration. If you insert the SD card which set the configuration into a black box, the configuration is automatically updated.

Original Viewer – Configuration

Configuration Default Settings

Configuration Setting and playback video on Smartphone

Recorded video by V300HD can be played back and deleted as well as setting configuration on a smartphone which supports only Android.

APP installation
SD card Location setup
Video file list
Configuration setup

Firmware Update

SD Card Format

How to format the card if the SD card has recognition error

Turn on the power while pressing the “REC” button.
While you press the “REC” button, the format will start.
When you press the “REC” button briefly within the format stand-by time, the SD card will be formatted and rebooted.
- If you press the “REC” button a little longer, it will be rebooted and even if stand-by time is over.

Specifications

Recordable Time

Below table is Recordable Time by setting value at “SD card Folder Capacity Adjustment” Based on 8GB with high resolution

Warranty

The products are manufactured through a strict quality control and inspection process.
The defect occurring in normal use of user within the warranty period will be repaired free of charge.

Warranty Details (Conditions) Free Service: The defect occurring under normal use within the warranty period from the date of purchase will be repaired free of charge. Paid Service: If the warranty period has passed. Even within the warranty period, the following cases shall be repaired at cost: Failures caused by natural disasters (fire, lightning, flood damage, etc.) Failures caused by carelessness using (drop, flooding, shock, breakage, excessive operation) Failures caused by the malfunction of power in use and connected equipment. Failures caused by any changes of a product and repaired from an unauthorized service centre.
Accessories are not repaired free of charge. The products other than the warranty period shall not be replaced free of charge. Important data shall be backed up in a safe place and we shall not be responsible for any loss of the data stored in the product.
- Date: D. M. Y.
- Distributor :

Customer Service
Manufacture: 303-305, Bucheon Technopark, #365, Samjeong-dong, Ojeong-gu, Bucheon-si, Gyeonggi-do, Korea 421-741 Please download the user manual, program from the below website

http://winycam-eng.com

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual >>