PROAIM QR-ELMG-01 Airwave Ultra Vibration Isolator Arm Instruction Manual
- June 16, 2024
- PROAIM
Table of Contents
Electro Magnet Quick Release Mitchel Mount
(QR-ELMG-01)
Assembly Manual
What’s In The Box
Please inspect the contents of your shipped package to ensure you have
received everything that is listed below.
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or
transmitted by any form or by any means, ectronic, mechanical, photo-copying,
recording, or otherwise, except as may be expressly permitted by the
applicable copyright statutes or in writing by the Publisher.
Electro Magnet Setup
Airwave Ultra Assembly
- Loose castle nut from top mount.
- Remove the bottom mounting plate from mounting plate by pulling button of mounting plate.
- Secure it by castle nut.
- Now attach it to airwave.
Vibration Isolator with Dampener Assembly
- Unlock the connector holder (Not Included) and press the button the gimbal connector (Not Included).
- Mount Gimbal connector to bottom mounting plate.
- Here is how both apart would look like (Not Included).
- Now secure it by using screw and Allen key.
- Attach the bottom mounting plate after flipping to top mounting plate by pulling button.
- Use the provided pin to secure release button.
NOTE: so that whenever your rigs are positioned beneath the magnet,
nobody can touch the button release, making it highly secure keeps the gadget
in place even when the batteries run out or lose power.
Air Filling Pump Assembly
- Mount the connector holder on gimbal.
- Now unscrew the connector holder to detach quick release plate(Not Included).
Vibration Isolator with Dampener Assembly
- Screw it with the help of Allen key
- Release the quick release plate from gimbal by unlocking knob.
- Now attach the gimbal to the mounting plate while pressing buttons of connector holder and secure by closing knob.
Air Filling Pump Assembly
- Attach the quick release plate to camera (Not Included) and secure it by the help of Allen key (Not Included).
- Now attach camera with plate to gimbal by sliding and close the knob back again.
Vibration Isolator with Dampener Assembly
- Here is the gimbal attached.
- Now loose lever lock to open clamp of battery plate.
- Mount the battery plate on the airwave and tighten the clamp to secure .
Air Filling Pump Assembly
- Attach one end of D-Type Cable to battery plate.
- Attach other end of D–type cable to mounting plate .
Vibration Isolator with Dampener Assembly
- Now attach battery on the battery plate by sliding.
- Turn switch on which is on the side of battery plate.
YOUR PROAIM AIRWAVE ULTRA VIBRATION ISOLATOR ARM ALL DRESSED UP AND READY
TO GO! (SHOWN WITH OPTIONAL ACCESSORIES)
Warranty: We offer one year warranty for our products from date of
purchase. Within this period of time, we will repair it without charge for
labor or parts. Warranty doesn’t cover transportation costs nor does it cover
a product subjected to misuse or accidental damage. Warranty repairs are
subjected to inspection and evaluation by us.
Liability: We are not liable for damage caused by products that we do not
supply or from mishandling in transit, accident, misuse, neglect, lack of care
of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissatisfaction, please Contact us
immediately and we promise our utmost support and care until you use our
product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>