FEIT electric LV/LANDSCAPE/RGBW/AG Smart Landscape Lighting Installation Guide

FEIT electric LV/LANDSCAPE/RGBW/AG Smart Landscape Lighting

Safety Information

IMPORTANT SAFEGUARDS:
ALWAYS FOLLOW BASIC SAFETY PRECAUTIONS WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN CHILDREN ARE PRESENT.

• CAUTION : Please read all information carefully before installation.
• CAUTION : Use on 12VDC or 12VAC (power adapter included) circuit. This product is not user-serviceable. Do not attempt to open the product enclosure for any reason. The reliable operating temperature is -4°F to 113°F (-20°C to 45°C).
• CAUTION : Do not use with dimmers.
• CAUTION : Make sure all connectors are tightly secured to prevent water entry.
• CAUTION : Do not use within 10 feet of a pool, spa or fountain.
• CAUTION : Suitable for wet locations. Intended for outdoor use.
• WARNING : This product may represent a possible shock or hazard if improperly installed or attached in any way. The product should be installed in accordance with the owner’s manual, current electrical codes, and/or the current National Electric Code (NEC).
• RISK OF ELECTRIC SHOCK: Turn off the main power at the circuit breaker before installing.
• WARNING : Do not exceed the total wattage of the power adapter or transformer rating.
• CAUTION : The instructions in this manual are not intended to cover every possible installation, operation, maintenance, or mounting situation.

Supplier’s Declaration of Conformity:
47 CFR § 2.1077 Compliance Information

Responsible Party:
Feit Electric Company 4901 Gregg Road, Pico Rivera,
CA 90660, USA 562-463-2852

Unique Identifier:
LV/LANDSCAPE/RGBW/AG

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and the receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. CAN ICES-005 (B).

• The device has been evaluated to meet the general RF exposure requirements.
• The device can be used in portable exposure conditions without restriction.
• The device can be used in mobile (min 7.87 in.) exposure conditions without restriction.

Limited Warranty

This product is warrantied to be free from defects in workmanship and materials for up to 1 year from the date of purchase. If the product fails within the warranty period, please visit feit.com/help for instructions on replacement/refund or call 866.326.BULB. REPLACEMENT OR REFUND IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY EXCLUDED. Some states and provinces do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state or province to province.

Pre-Installation

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.

Description

enter pairing mode.

Installation

1. Planting the Mounting Stake in the Ground

   • Find the desired location. Plant the mounting stake (CC) by firmly pressing it into the soil, use a rubber mallet (not included) if necessary, until the entire stake is in the ground.
     NOTE: If the soil is hard, dig or wet the ground, to make it easier to plant the stake.

2. Attach Smart Landscape Light to Mounting Stake

   • Make sure to clear out the debris on top of the stake. The cables can go through the base slot of the mounting stake (CC). Attach the Smart Landscape Light (AA) to mounting stake (CC). Rotate to the desired position before fastening the barrel nut clockwise until it is fully secure.
     NOTE: Cables can be buried at a maximum depth of six inches. Make sure all connectors are tightly secured.

3. Adjust the Head Angle

   • Loosen the thumbscrew by turning counterclockwise. Adjust the Smart Landscape Lights (AA) to the desired angle.
   • Fasten the thumbscrew by turning it clockwise until it is fully secure.

4. Attach the Power Adapter to the Smart Landscape Light

   • Once the Smart Landscape Light (AA) is planted in the ground, connect the 15 ft. extension cable (DD) to the Smart Landscape Light (AA). The connectors are designed to only connect one way.
   • Connect the power adapter (BB) to the 15 ft. extension cable (DD).
   • Securely attach an end cap on the remaining connector of the Smart Landscape Light (AA) if you are not connecting to additional Smart Landscape Lights (sold separately).
   • Plug the power adapter (BB) into an outdoor-rated GFCI receptacle with an appropriate outdoor cover.

5. (Optional) Connect additional Smart Landscape Lights

   • Connecting additional Smart Landscape Lights will require a power adapter or transformer with a higher wattage rating. Make sure the load does not exceed it.
   • The voltage provided to each Smart Landscape Light (AA) must be within the input voltage range.
   • Securely attach an end cap at the end of the remaining connector of the Smart Landscape Light (AA).
     NOTE: The supplied power adapter (BB) can only be used with one Smart Landscape Light (AA).

APP Setup

Download and install the Feit Electric app

• Search for the Feit Electric app in the App Store or Google Play Store.
• Download and install the Feit Electric app on your smart device.

NOTE: Be sure to connect to a 2.4GHz Wi-Fi network that covers your installation location.

Need Help?
Thank you for your purchase. Questions, comments or feedback?We’d love to hear from you.

Visit feit.com/help for support or connect with us:

Connect Your Device

Open the Feit Electric app to complete the setup

• Tap Add Device or the + sign.

NOTE:
The device must be rapidly blinking to connect. If not already blinking, press and hold the Reset Button for five seconds to enter pairing mode.

Turn on Bluetooth

• The device name(s) will pop up on the Feit Electric app. Tap on Go to add, then select the device to add.
• You will be prompted to enter your Wi-Fi network name and password.
• Only one device may be added at a time using Bluetooth setup. Repeat this step to add additional devices.
• Alternative setup options and help instructions are available in the Feit Electric app.

Troubleshooting Tips

If you are having difficulty connecting:

• Make sure the Wi-Fi network is a 2.4GHz network. Feit Electric smart device will not connect to a 5GHz network.
• Test your Wi-Fi network with other devices such as your phone to make sure it is operating properly.
• The Wi-Fi connection may not have good coverage during setup. Try moving the device closer to your Wi-Fi router.
• Your Wi-Fi network password is case-sensitive, make sure you are entering it correctly.

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | www.feit.com.

References

• Energy Saving Light Bulbs, Light Fixtures | CFL, LED & More

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>