Baseus PPCXM10B Power Bank User Manual
- June 16, 2024
- Baseus
Table of Contents
User Manual
Warnings
Improper use of the product may lead to battery malfunction or severe overheating, and may even cause fire or explosion. Ta avoid any damage to you and your property, please follow the instructions below when you use and store the product.
- This is NOT a toy’ Please place this product in areas that are not easily accessible by children. Do not allow children ta operate this product, or accidents may occur.
- Please charge this product with a charger approved by the local safety standards in case of danger or damage.
- D0 NOT apply pressure, and avoid collisions. The battery and circuit may be damaged if this product falls from a great height, experiences intense shocks, oris immersed in liquid; if so, please avoid using this product.
- If this product suffers fram deformation, leakage, or radical decline in performance, please stop using this Product.
- Please GO NOT charge any device or recharge this product in places that may affect its heat dissipation, such as pants pockets, enclosed bags, beds, or couches. And ensure this productis not under any cover when operating. When charging other devices for prolonged periods, DO NOT stack any device on top of this product, or it might affect its heat dissipation.
- This product CAN NOT be disassembled, applied pressure, pierced, short-circuited, immersed in liquid, disposed of in a fire, or exposed to a high tem perature or heat source with a tem perature greater than 140°F (60°C).
- D0 NOT place this product in areas with extremely high temperatures. Such as under direct sunlight or ina vehicle with a very high interior temperature.
- This product contains lithium batteries, DO NOT disassemble it! Or danger or battery damage may occur.
Attention
- Please fully charge this device before using it for the first time.
- The power banks have conversion efficiency, so the battery capacity of power bank is not equal to the rechargeable capacity.
- Please choose an appropriate charger for recharging this product and suitable cables when charging other devices.
- Please ensure some supervision is in progress when recharging this product, DO NOT charge this product without any care.
- Please remove the cable when done recharging this product or finished chargyng for any other device to preserve the product integrity.
- If the indication does not light up after pressing the power button, please recharge this product.
- Please preserve this product with a battery percentage between 2596-50% for long-term storage. Place this product in a cool and dry environment. To slow down battery aging, avoid storing this product in an empty or full charge for long-term storage.
- Please do not dismantle the product by yourself. Improper use or placement may compromise the service life or damage the product, to which our company will not bear any legal responsibilities nor offer any guarantee. Please understand.
Product Parameter
Name: Power Bank
Model No.. PPCXM10
Battery: Polymer Lithium Battery
Power Capacity: 10000mAh / 37Wh
Energy Conversion Rate: ≥75%
Type-C Input: 5V-3A; 9V-2A
Type-C Output. 5V-2.4A; 9V-2.22A; 12V-1.5A
Wireless Output: 5W/7.5W/10W/15W
Total Output: 5V-2.4A
Product Size: 104.6 x 68.9 x 20mm
Product Weight: About 208g
Packing list
Power Bank x1
User Manual x1
Warranty Card x1
Charging Cable x1
Product Schematic Design
Product Description
This product is a portable charging device that can provide wired and wireless charging for mobile phones, tablets, game consoles and other digital products. The product has auto=alignment for magnetic charging, and supports Apple 20W PD fast charging, Type-C dualway fast charging, 15W wireless fast charging, etc. It has built-in FOD, overcharge, overedischarge, temperature protection and other safety protection circuits.
Use Environment
Working Temperature: Non-tropical areas, 0°C to 40 °C
Storage ambient temperature: 0 °C to 40 °C
Icon Description
The 5-year icon refers to the “valid environment-friendly use period”, not the
product quality assurance period.
Electronic products contain toxic and harmful substances such as lead, mercury
and cadmium. The overdue use of these products may lead to leakage or mutation
of these taxic and harmful substances, cause environment polluvon or serious
damage to people and property. The term of “environmentfriendly use penod’
means that all electronic products shall be used within this validity period.
We are free of any responsibility against safety issues caused by using the
product beyond its safe service life.
Operation Instructions
To check battery status:
Press the button once to check the battery status (remaining power). The
indicator will light up about 30s before it automatically tums off
When charging using a cable:
The power bank will automatically starts to output when you connect a
charging cable to it. However, due to compatibility issues, for some phones
you need to press the power button once to start charging The output mode will
stay for 20s after you press the button, during which if there’ s no device
connected, the mode will automatically shut down.
When charging wirelessty:
This product has an auto-wake function for wireless charging, just place
your phone onto it, and it will automatically start charging. But for some
phones, due to compatibility issues, the wireless chargyng functon needs to be
activated by pressing the button. Press it once, the battery indicator will
light up and the wireless charging ts turned on, and you can place your device
on. If there’s no load connected for the wireless charging in 30s, the product
will automatically shut off the wireless charging function.
Wireless Charging Tips
Place your phone onto the wreless charging area (as it shows in the prcture) for wreless charging The distance between the charging phone and the power bank must be within 8mm for wireless charging to work, if not it will stop charging, and you need to adjust the phone’ s position.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1)this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
CE Statement
Herby, Shenzhen Baseus Technology Co., Ltd.declares that this Power Bank,
PPCXM10 is in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU.
In accordance with Article 10(2) and Article 10(10), this product allowed to
be used in all EU member states.
Use the Power Bank in the environment with the temperature between -10℃ and
40℃ Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to the instructions.
Operation Frequency:112-205KHz
Manufacturer：Shenzhen Baseus Technology Co., Ltd.
Address： 2nd Floor, Building B, Baseus Intelligence Park, No.2008, Xuegang
Rd,Gangtou Community, Bantian Street, Longgang District, Shenzhen.
E-mail: zhangmao@baseus.com
European agency
Apex CE Specialists GmbH
Habichtweg 1 41468 Neuss Germany
| AT| BE| BG| HR| CY| CZ| DK
---|---|---|---|---|---|---|---
EE| Fl| FR| DE| EL| HU| IE
IT| LV| LT| LU| MT| NL| PL
PT| RO| SK| SI| ES| SE| UK
DECLARATION OF CONFORMITY
I hereby declare that the product
Product:
Product Name: Power Bank
Model: PPCXM10
Brand Name: baseus
Hardware Version: V2.2
Software Version: EB269549
Accessories：
Battery information
Model: H676076CH
Specification: 3.7V, 5000mAh, 18.5Wh
Manufacturer: Apex(WuXi)Co.,Ltd
Battery information
Model: 676076GH
Specification: 3.7V, 5000mAh, 18.5Wh
Manufacturer: EVE Energy Co.,Ltd
satisfies all the technical regulations applicable to the product within the
scope of Council Directives 2014/53/EU, 2014/35/EU and 2014/30/EU:and declare
that the same application has not been lodged with any other notified body.
EN 62479:2010
EN 62311:2020
ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-3 V2.1.1 (2019-03)
ETSI EN 303 417 V1.1.1 (2017-09)
EN 55032:2015+A11:2020+A1:2020
EN 55035:2017+A11:2020
EN 61000-3-2:2019+A1:2021
EN 61000-3-3:2013+A1:2019
EN 62368-1:2020+A11:2020
All essential radio test suites have been carried out.
NOTIFIED BODY: MiCOM Labs Inc
- Address:
575 Boulder Court, Pleasanton, California94566
USA
Identification Number: 2280
MANUFACTURER or AUTHORISED REPRESENTATIVE: Shenzhen Baseus Technology Co., Ltd.
- Address:
2nd Floor,Building B,Baseus Intelligence Park,No. 2008,Xuegang Rd,Gangtou Community,Bantian Street, Longgang District, Shenzhen, China
This declaration is issued under the sole responsibility of the manufacturer and, if applicable, his authorised representative.
Point of contact:
(Name, telephone and fax number)
2 nd Floor,Building B,Baseus Intelligence Park,No. 2008,Xuegang Rd,Gangtou
Community,Bantian Street, Longgang District, Shenzhen
(Place, date of issue)
2024/01/9
(Signature)
Zhang Mao / Certified Engineer
(Name and title in block letters)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>