COSTWAY TQ10145 Kids Ride On Excavator Instruction Manual

TQ10145 Kids Ride On Excavator
Instruction Manual

WARNING
ADULT ASSEMBLEY REQUEST. 2022 Caterpillar. CAT,CATERPILLAR, and their design and marks are registered trademarks of Caterpillar Inc. Ningbo Prince Toys Co.,Ltd.,a licensee of Caterpillar Inc.
Before You Start
Please read all instructions carefully and keep it for future reference.

General Warnings

Danger! Keep all small parts and packaging materials for this product away from babies and children, otherwise they may pose a choking hazard.
The product must be installed and used under the supervision of an adult.
Read through each step carefully and follow the proper order.
Remove all packaging, separate and count all parts and hardware before installation.
Please ensure that all parts are correctly installed, incorrect installation can lead to a danger.
We recommend that, where possible, all items are assembled near the area in which they will be placed in use, to avoid moving the product unnecessarily once assembled.
Ensure a secure surface during installation, and place the product always on a flat, steady and stable surface.

‘Warning:

1. Ride-on car is designed for children up 12-36 months old. Ride’s weight must not exceed 25 kg as there is insufficient trength to support overweight.
2. Product is designed to seat 1 child as a time to avoid njuries.
3. Parental guidance and supervision are strongly advised to ensure safe riding.
4. Adult assembly and installation of all parts are required to ensure safety.
5. Batteries to be handled by adults.
6. Take care of riding and avoid going near streets, crossroads, all traffic areas, swimming pools and stairs.
7. Without regular check of the product, it will cause overturn or fall.
8. Check to see occasionally that the nut and bolt on the steering wheel is tight and secure.
9. Dangers may present if the product is not correctly assembled.
10. Shoes must be worn in use.
11. Colored stickers shall be pasted by customers themselves.

Battery Handling:

1. Battery must be handled by adults only.
2. Always remove exhausted batteries.
3. Use two AAA batteries (not included) only.
4. lkaline batteries are recommended.
5. AIways remove batteries when the unit is not going to be used for an extended period of time.
6. When replacing new batteries, always replace all batteries.
7. Do not mix old and new batteries.
8. Do not mix Alkaline Standard(Carbon-Zinc), or Rechargeable(Nickel-Cadmium) batteries.
9. Do not dispose of batteries in fire, batteries may explode or leak.
10.  Non-rechargeable batteries are not to be recharged.
11. Rechargeable batteries are to be removed from the toy before being charged.
12. Rechargeable batteries are only to be charged under adult supervision.
13. Batteries are to be inserted with the correct polarity.
14. The supply terminals are not to be short-circuited.

COMPONENTS LIST

COMPONENTS LIST

ASSEMBLY

1. Remove the bolt and nut pre-installed on the steering wheel. Use a Phillips screwdriver to counter-rotate the screw until the nut comes loose. (Figure 1)
2. Install the J-shaped stick. Turn the body over and insert the J-shaped stick through the mounting hole at the bottom of the body, with the hook part stuck in the long hole of the steering rack and the J-shaped stick threaded out on the other side of the body. (Figure 2)
3. As the upper part of the J-shaped stick pierced out of the body, put in the steering wheel that has removed the bolt, while holding the bent hook part of the J-shaped stick at the  bottom of the car, rotate the steering wheel, use the bolt hole of the steering wheel to align with the hole on the J-shaped stick, insert the bolt and nut, and tighten them (Figure 3).
4. Remove the bolt and nut of the car body as shown; put the spring end of the digging arm into the square hole of the car body, install the bolt and nut at the same time, and tighten them. (Figure 4)
5. Install the handle bar into the hole on the igging arm, note the hexagonal square hole with a positioning slot to limit the position, and fasten it with a screw on the other side. (Figure 5)
6. Install the backrest of the car into the corresponding hole behind the seat. Note that the backrest has the hole side to the rear side. (Figure 6)

BATTERY CHANGE

1. Loosen the screws with a Phillips screwdriver in the direction shown, and pull up the battery cover in the middle of the steering wheel. (Figure 1)
2. Make sure that the positive and negative poles of the battery correspond to the positive and negative poles of the steering wheel battery compartment, and then install the battery. (Figure 2)
3. Put back the battery cover, tighten the screw. (Figure 3)

FUNCTION

Return / Damage Claim Instructions

DO NOT discard the box / original packaging.
In case a return is required, the item must be returned in original box. Without this your return will not be accepted.
Take a photo of the box markings.
A photo of the markings (text) on the side of the box is required in case a part is needed for replacement. This helps our staff identify your product number to ensure you receive the correct parts.
Take a photo of the damaged part (if applicable).
A photo of the damage is always required to file a claim and get your replacement or refund processed quickly. Please make sure you have the box even if it is damaged.
Send us an email with the images requested.
Email us directly from marketplace where your item was purchased with the attached images and a description of your claim.

Kids Ride-On Excavator
TQ10145
USA office: Fontana
USA:cs.us@costway.com
If you’re having difficulty, our friendly customer team is always here to help.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>