UGREEN 15951 Portable Electric Air Compressor User Manual
- June 16, 2024
- UGREEN
Table of Contents
Portable Electric Air
Compressor
User Manual
15951 Portable Electric Air Compressor
Dear customer,
Thank you for purchasing our product. Please read the following instructions
carefully before first use and keep this user manual for future reference. Pay
particular attention to the safety instructions. If you have any questions or
comments about the device, please contact the customer line.
www.alza.co.uk/kontakt
✆ +44 (0)203 514 4411
Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7,
www.alza.cz
Package Contents
Product Overview
Battery Status & Charging
Fully charge the inflator before the first use or using it after a long time
of storage.
Charge the inflator with a 5V/2A power adapter and the supplied charging
cable.
Note : Do not use the inflator during charging.
Installing the Adapter
Power On/Off
To power on/off: Press and hold the start/stop button for two seconds.
Note : The inflator will turn off automatically if there is no operation
within three minutes after turning on.
Determining the Required Air Pressure
Please refer to the instructions to determine the required air pressure before
installing to ensure safety and avoid injury from an explosion caused by over-
inflation.
For tires, the required air pressure is indicated on the sidewall of the tire,
or on a sign placed to the driver’s door frame.
For balls, the required air pressure is indicated near the air valve of the
ball.
Category | Type | Recommended pressure range |
---|---|---|
Balls | Basketball | 7-9 psi |
Football | 8-16 psi | |
Volleyball | 4-5 psi | |
Bicycles | 12-16″ bicycle tires | 30-50 psi |
20-24″ bicycle tires | 40-50 psi | |
Mountain bike tires | 45-65 psi | |
Electric scooter tires | 45-50 psi | |
Road bicycle tires | 100-130 psi | |
Motorcycles | Motorcycle tires | 1.8-3 bar |
Cars | Car tires | 2.2-2.8 bar |
Note : The pressure range values are for reference only. Please refer to the instructions or manual of the item that is being inflated for exact inflation pressure parameters.
Presetting Air Pressure
Mode selection: Press the mode button to switch between inflation modes.
Please ensure choosing of the right pressure unit before inflating, you can
press and hold the button for three seconds to toggle units between psi, bar,
and kPa.
Manual mode: No icon displayed. The air pressure is adjustable, and the
value and unit will be saved.
Adjusting the preset pressure: After the mode selection, you can press (+) or
(-) to adjust preset pressure. Press and hold to quickly adjust the value.
When adjusting, the blinking value indicates the adjustable target pressure,
and a nonblinking value indicates the real time pressure.
Inflating
Start inflating: Press the start/stop button to start inflating. While inflating, the current pressure is displayed in real time.
When inflating, the tire inflator may be as loud as 75-80dB. Please take
appropriate precautions to protect your hearing.
The tire inflator and air hose can get very hot after running for a while.
Avoid prolonged skin contact with the hose to prevent injuries.
Stop inflating: The tire inflator will automatically stop inflating once the
preset pressure value has been reached. The tire inflator can also be manually
stopped at any time while inflating by pressing the start/stop button. When
the inflating is finished, quickly disconnect the air hose from the valve to
avoid pressure loss.
Items such as balloons, beach balls, and swimming rings cannot be
automatically inflated because they have an air pressure requirement below the
tire inflator’s minimum pressure range. Please inflate these items manually
with cautions.
Flashlight
The inflator is equipped with a flashlight to help you use it in the dark. You
can also use the warning or SOS function to ask for help if needed.
Press once to turn the flashlight on, press twice to turn on the warning mode,
and press three times to turn on the SOS mode.
Troubleshooting
Problem | Solution |
---|---|
Slow inflation speed. | Make sure the product is fully charged. |
Make sure the air hose is not leaking.
Make sure both ends of the air hose are firmly connected.
Make sure the item that is being inflated is not leaking.
Tire inflator turns on but does not inflate.| Make sure the product is fully
charged.
Check to see if the inflated item’s pressure is higher than the preset
pressure.
Unable to increase or decrease the preset
pressure.| Make sure the tire inflator is set to the correct mode. The preset
value can be adjusted within a range of 3-150 psi in the user-defined mode,
which displays values only with no icons.
Notes
- Users should be at least 16 years old.
- Keep a safe distance from the inflator and keep a constant eye on the inflation process to prevent the air pressure from getting too high if there is no preset value.
- The product has a built-in motor that may cause a spark during use. Do not operate it in flammable and combustible environments.
- To avoid a flat tire, make sure you select the correct unit when selecting the pressure value. The common conversions: 1 bar = 14.5 psi = 100 kPa.
- Stop all use when the inflator makes an abnormal sound or overheats during operation.
- Please use the product in a dry and clean environment; dust incursion could cause damage. Do not wash the product since it is not waterproof.
- The tire inflator’s battery lasts about 40 minutes on a full charge running without a load at an ambient temperature of 25°C. Using the tire inflator under a heavy load or at lower ambient temperatures may reduce its battery life.
- Use or store the product and accessories where the ambient temperature is between -10~45°C. Low- or high-temperature conditions might cause damage to the battery.
- When not in use, store the product in a dry environment. To preserve lifespan, recharge and discharge it every three months.
- Uncertified or incompatible power adapters, charging cables, or batteries may cause fire, explosion, or other hazards.
- Persons (including children) with reduced physical, sensory, or mental capabilities, as well as those who lack basic understanding of the product, should only use this product with supervision or guidance on how to operate the appliance safely and understand the risks associated.
Warning
- This product contains small parts, please do not use it as a toy for children to prevent swallowing.
- The product contains built-in lithium-ion battery, please do not dismantle, crush, squeeze, or expose it to fire.
- If the battery is severely swollen, please stop using it.
- Do not expose the inflator to excessive temperature.
- Do not use inflator if the battery has been submerged.
- Keep out of reach of children.
- Do not attempt to inflate the human body.
Specifications
Input | 5.0V⎓2.0A |
---|---|
Pressure range | 0.2~10.3bar / 3~150psi |
Sensor accuracy range | ±2psi |
Battery type | Lithium-ion battery |
Battery capacity | TYP: 2500mAh 7.2V (18.0Wh) / MIN: 2450mAh 7.2V (17.64Wh) |
Operating current | Max. 10A |
Charging port | USB-C |
Charging time | 3 hours |
Operating noise | <80dB (1 metre away from the inflator) |
Operating temperature | 0~40°C |
Storage temperature | -10~45°C |
Warranty Conditions
A new product purchased in the Alza.cz sales network is guaranteed for 2
years. If you need repair or other services during the warranty period,
contact the product seller directly, you must provide the original proof of
purchase with the date of purchase.
The following are considered to be a conflict with the warranty conditions,
for which the claimed claim may not be recognized:
- Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation, and service of the product.
- Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g., during transport, cleaning by inappropriate means, etc.).
- Natural wear and aging of consumables or components during use (such as batteries, etc.).
- Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.
- If anyone has made modifications, modifications, alterations to the design or adaptation to change or extend the functions of the product compared to the purchased design or use of non-original components.
EU Declaration of Conformity
This equipment is in compliance with the essential requirements and other relevant provisions of EU directives.
WEEE
This product must not be disposed of as normal household waste in
accordance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE – 2012/19 / EU).
Instead, it shall be returned to the place of purchase or handed over to a
public collection point for the recyclable waste. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences
for the environment and human health, which could otherwise be caused by
inappropriate waste handling of this product. Contact your local authority or
the nearest collection point for further details. Improper disposal of this
type of waste may result in fines in accordance with national regulations.
References
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- alza.at
- Alza | Alza.co.uk
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza.cz
- alza.de
- alza.hu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>