TITAN TIST4412 Wood Post Anchor Installation Guide
- June 16, 2024
- Titan
Table of Contents
TITAN TIST4412 Wood Post Anchor
IMPORTANT
Do not use on surfaces 30″ or higher ( U.S.A.) or 600mm / 23.62″ ( CAN ) or higher UNLESS you build according to our Engineering Reports ( See QR link below) AND obtain approval by your local authority.
Use only Stainless Steel Screws with Aluminum Decking. Sold Separately.
RECOMMENDED TOOLS
|
---|---
Socket 9/16″ ( 14 mm )
|
3 lbs. Hammer
|
Ratchet or Drill
|
Hole Saw 1-1 /4″ 32 mm dia.
|
T27
Driver Bit
|
Forester Bit
Hardwood Installations Only
TITAN WOOD POST ANCHORTM KIT
(8) *Wood Screw #14X4” T27 Drive
(4) Lag Screw 3/8” X 5”*
*Concrete screws sold separately.
INSTALLATION INSTRUCTION
RECOMMENDED ACCESSORY
USE WHEREVER EXTRA STRENGTH IS DESIRED
POST BRACE DETAIL
PRE-DRILL LAG SCREW TIP
USE A 5 /16 ” BIT AND PRE -DRILL AT LEAST 4” DEEP BEFORE INSTALLING 3/8” LAG SCREWS.
LAG SCREW/ DRILL BIT GUIDE
SOFTWOOD POST
3/8” LAG SCREW
5/16″ [) RI LL BIT
1/2” LAG SCREW
7/60″ R I LL BIT
HARDWOOD POST
3/8” LAG SCREW
11/32” DRILL BIT
1/2″ LAG SCREW
15 /32″ DRILL BIT
**FOR VERY DRY WOOD, WET ENDS OF POST WITH WATER BEFORE USE TO PREVENT CRACKING.
**
4×4/4×6 | concrete | INSTALLATION
-
DRILL (1) CORNER HOLE & INSTALL (1) SCREW IN ANCHOR. DRILL (3) CORNER HOLES.
*Concrete screws sold separately. ¼” x 2-¼” min. screw size.
-
REMOVE ANCHOR. INSTALL REMAINING SCREWS. ( With Wood Post)
ENGINEERING REPORTS FOR APPLICATION SUITABILTY
ATTENTION
- Do not use this product for residential code guard rails UNLESS you have a local engineer or inspector approve your application in your area. Do not use this product as a stand alone post. It has not been tested for use with vinyl rail systems.
- lntertek engineering reports are for guidance only and complying with them does not necessarily mean your structure will be code compliant. Any variation from the assemblies tested in our engineering reports is outside of the scope of the report.
- This product is not for industrial, commercial or apartment building applications. It is for private residential use only.
4×4/4×6 | Hardwood | WOOD POST ANCHOR | INSTALLATION
IMPORTANT
Use only Stainless Steel Screws with Aluminum Decking. Sold Separately.
ATTENTION
-
This product is not for industrial, commercial or apartment bU1ilding applications. It is for private residential use only.
If you wish to use this product for any residential code application including a railing, engage local professionals before beginning work: (i) to ensure that this product is appropriate for your intended use and that the structural components which this product is to be used in conjunction with are sound and that the work area is safe and free from all potential hazards including utilities and other services, (ii) to provide clarification if these warnings are unclear or you do not understand any of the information in the installation instructions for this product. Always comply with applicable building codes. Be aware that building codes may vary. -
In no event shall Titan Building Products be liable for any loss or damage, direct or otherwise, which results from the improper use of this product. If for any reason Titan Building Products becomes liable for loss or damage, direct or otherwise the aggregate liability of Titan Building Products shall be limited to the retail purchase price of the products.
