Bestway 41502 Royal Seahorse Ride On Pool Float Instruction Manual
- June 16, 2024
- Bestway
Table of Contents
Bestway 41502 Royal Seahorse Ride On Pool Float
Product Information
Specifications
- Product Model: 41502
- Dimensions: 1.91 m x 1.19 m / 6’3″ x 46.5″
- Working Pressure: 0.03 bar
- Maximum Load Capacity: 2 x 30 kg
Product Usage Instructions
Inflation
- Before using the product, carefully check if there are any leaks or broken parts.
- Open the valve and use an air pump (not included) to inflate the product to the design working pressure of 0.03 bar.
- Fill the chambers until most of the wrinkles are gone and it feels firm to touch, but not hard. If you use other pressure, make sure not to overinflate.
Deflation
- Open the valve and allow the air to escape.
Maintenance and Storage
-
After deflation, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the product. -
Store the product in a cool, dry place and out of children’s reach.
-
Check the product for any damage at the beginning of each season and at regular intervals when in use.
Repair
- If a chamber is damaged, use the provided repair patch.
- Clean the area to be repaired.
- Carefully peel the patch and press it over the damaged area.
- Wait for 30 minutes before inflating the product again.
FAQ
Q: Can children under 3 years of age use this product?
A: No, this product is not suitable for children 3 years of age and below.
It should only be used by children above 3 years of age.
Q: What is the maximum load capacity of this product?
A: The maximum load capacity is 60 kg, allowing for a maximum of 2
children.
Q: Do I need to supervise children while they are in the water?
A: Yes, it is always important to supervise children when they are in the
water, even when using this product.
Q: Can this product be used for anything other than swimming?
A: No, this product is intended for pool use only.
Q: Are there any specific balancing requirements for using this product?
A: Yes, this device requires balancing while in use.
-
2023 Bestway Inflatables & Material Corp. All rights reserved
-
Inflatables & Material Corp., Shanghai, China Manufactured, distributed, and represented in the European Union by
-
Bestway Central & South America Ltda, Salar Ascotan 1282, Parque Enea, Pudahuel, Santiago, Chile Distributed in Australia & New Zealand by Bestway Australia Pty Ltd, Unit 2/98-104 Carnarvon St Silverwater, NSW 2128, Australia Tel:
-
Australia: +61 2 9037 1388; New Zealand: +0800 142 101 Distributed in the United Kingdom by Bestway Corp UK Ltd. 8 Wentworth Road, Heathfield Industrial Estate, Newton Abbot, Devon, TQ12 6TL Exported by
-
Bestway (Hong Kong) International Ltd./Bestway Enterprise Company Limited Suite 713, 7/Floor, East Wing, Tsim Sha Tsui Centre, 66 Mody Road, Kowloon, Hong Kong
www.bestwaycorp.com -
303021321253_41502_14x21cm
OVERVIEW
PRECAUTION
- WARNING
- PROHIBITION
- MANDATORY
- NO PROTECTION AGAINST DROWNING
- DESIGN WORKING PRESSURE: 0.03 BAR
- NOT FOR CHILDREN 3 YEARS OF AGE AND BELOW, APPLY ONLY TO CHILDREN ABOVE 3 YEARS OF AGE
- READ INSTRUCTIONS FIRST
- NUMBER OF USERS, 2 CHILDREN
- SWIMMERS ONLY
- MAXIMUM LOAD CAPACITY 60 KG
- FULLY INFLATE ALL AIR CHAMBERS
- ALWAYS SUPERVISE CHILDREN IN WATER
- POOL USE ONLY
- DEVICE REQUIRES BALANCING
WARNING
Read the manual and follow the instructions relating to safety tips, correct and complete product assembly, setting into service, use and maintenance. For your own safety, always heed the advice and warnings in these instructions. Non-compliance with these operating instructions may expose you to danger. Only use the product in the places and conditions for which it is intended.
- ATTENTION! NO PROTECTION AGAINST DROWNING!
- SWIMMERS ONLY!
- POOL USE ONLY!
- Full inflate all air chambers.
- Passenger numbers and load weight shall by no means exceed passenger number and maximum weight capacity in specifications.
- This product should not be used as a life-saving device.
- Life-saving devices (life jackets and life buoys) must be prepared together and inspected.
- The product must be used with over three years old. Please use balance!
- Keep away from flames and fires.
- Before every use, carefully inspect all product components, to ensure everything is in good condition and tightly secured. Please stop to repair if you find any damage.
- Be careful when landing on the ground. Sharp and rough objects such as rocks, cement, shells, glass, etc. may puncture the product.
- Don’t leave the product exposed to the sun for long periods, as high temperatures shall give rise to air expansion, which can cause irreparable damage.
- Only to be used in water in which the child is within its depth and under adult supervision.
- Need adult help to keep balance.
- No standing on the toy.
- Always grab your toy when using it.
- Do not use your product if you suspect a puncture or leak.
- Proper inflation and use are critical to ensure safety. Pay attention to ensure the safety valve is tightly closed each time in use.
- Check seams regularly for tears.
- Evenly distribute loads when using the product. Tipping and drowning may occur with uneven distribution of loads.
- NOTE: Do not over-inflate. Do not use an air compressor or compressed air.
- NOTE: Never stand on or rest objects on the product during inflation.
- NOTE: Always check the product for leaks before use.
INFLATION
-
Before using the product, carefully check if there are any leaks or broken parts. Open the valve and inflate with the air pump (not included) to design working pressure on the product.
-
Fill the chambers until most of the wrinkles are gone and it feels firm to touch but NOT hard. If you use another pressure gauge, the pressure should not be more than the specified pressure on the product or on the instruction. Do not over-inflate the product. Do not use an air compressor.
NOTE: Under and over-inflation of the product will result in safety hazards. It is better to check the pressure of the product each time before using it. -
Be sure to close the valves after inflation, press in the safety valves after inflation.
NOTE: Never stand on or rest objects on the product during inflation. Always check the product for leaks before use.
DEFLATION
MAINTENANCE AND STORAGE
-
After deflation, use a damp cloth to gently clean all surfaces.
NOTE: Never use solvents or other chemicals that may damage the product. -
Store in a cool, dry place and out of children’s reach.
-
Check the product for damage at the beginning of each season and at regular intervals when in use.
REPAIR
If a chamber is damaged use the provided repair patch.
- Clean area to be repaired.
- Carefully peel the patch.
- Press the patch over the area to be repaired.
- Wait 30 minutes before inflation.