Goodhome ASL1027-I Black Solar Powered Cool white Integrated LED Floodlight 800lm User Manual

Goodhome ASL1027-I Black Solar Powered Cool white Integrated LED Floodlight 800lm

Safety

• These instructions are for your safety.
  Please read through them thoroughly prior to installation and retain them for future reference.

• Check the pack and make sure you have all of the parts listed.

• Remove all packaging, wrap etc from the product.

• Decide on the appropriate location for your product.
  CAUTION: IP44 is guaranteed when the product is properly installed and sealed.

• Always avoid the product to be located at corrosive environment.

• Always refer to the installation drawing for the orientation of the product.

• The product must be securely fixed to the mounting surface using the screws and wall plugs supplied. The screws and wall plugs supplied are suitable for “masonry” only.
  Other fixings not supplied and must be purchased.

• Remove them from the battery compartment with a cloth if battery is leaked. Different types of batteries or new and used batteries are not to be mixed.
  The battery must be removed from the luminaire before it is scrapped. The battery is to be disposed of safely.

• The operating time depends on the charging performance in daytime. This would be affected by enviornment e.g. weather condition and location.

• To ensure proper product operation, the batteries must first be fully charged for two days MINIMUM . To do this, the product has to be turned off the first two days.

• It is recommended to have a regular schedule of care and maintenance to keep the surface condition well.

Technical Data

Bulb type:

| LED (Max. 2.6 W)
The light source of this luminaire
is not replaceable; when the light
source reaches its end of life the
whole luminaire shall be replaced.
---|---

Battery:

| 1 x 3.7 V 600 mAh. This battery is
not replaceable.

| This product complies with
conformity requirements of the
applicable European Regulations
or Directives.

| This product complies with
conformity requirements of the
applicable UK Regulations.

| Splashproof

| Waste electrical products
should not be disposed of with
household waste. Please recycle
where facilities exist. Check with
your Local Authority or local
store for recycling advice

xxWyy

| xx-year; yy-week of the year

Troubleshooting

The sensor is aimed in the wrong direction. Detection zone not properly targeted.| Re-aim the sensor to cover the desired area.
Another light source is causing the unit to think it is daylight.| Turn off surrounding lights and/or re-aim the sensor head.
The light comes on during the day.| Unit is located at shaded area.| Shine a flashlight onto the sensor.  If the light turns off then the fixture is mounted in an area that does not allow enough light to enter the sensor. Relocate the product.
The light comes on for no apparent reason.| Wind is moving trees and bushes in the detection zone.| Relocate the unit.
Cars in the street are being detected.| Relocate the unit.
Reflective objects (such as swimming pool) in the coverage area.| Relocate the unit.
Sunlight is falling onto the lens.| Mount unit in a sheltered place.
Unit is sensing motion in the detection zone.| Test the motion sensor by covering up the front curved lens with cardboard to block the view. If the light turns off then something in the detection zone is triggering the sensor. Relocate the unit.
Coverage area of sensor is poor.| Choose a suitable location for installing the product, away from trees, hot ventilator dusts, street lighting and traffic, which may interfere with its operation.| Relocate the unit.
Symptom| Possible Cause| Solution
---|---|---
The lights stay on continuously.| The sensor may be picking up a heat source, such as an air vent, dryer vent, or bright painted, heat-reflective surface.| Relocate the unit.
The unit may be suffering from false activation.| Cover the sensor lens completely with a thick cloth. This will prevent the sensor from “”seeing”” anything. If the unit now switches off after the set time duration and does not re-activate, this indicates that the problem was caused by false activation.
Slightly adjusting the direction / angle of the sensor head.
Ensure the unit is not positioned to

people using roads / footpaths next to your property. Occasionally, wind may activate the sensor. (Sometimes passages between buildings etc. can cause a “wind tunnel” effect.)

| Relocate the unit.
The lights flash on and off.| Heat or light from the bulbs may be turning the sensor on and off.| Relocate the unit, away from the light source.
Heat is being reflected from other objects and may be turning the sensor on and off.| Relocate the unit.
Sensor is sensing reflected light from the light fixture.|

1. Change position of light head aim light away from the reflecting surfaces.
2. Relocate the unit to a different location where it no longer causes reflected light.

Sensor will not operate at night.| The level of ambient light in the area may be too bright to allow operation.| Relocate the unit.
Another light source is causing the unit to think it is daylight.| Turn off surrounding lights and/or relocate the unit.
When setting the controls in daylight the detection distance becomes shorter.| Interference by sunlight.| Re-set controls at night.

Guarantee

• We take special care to select high quality materials and use manufacturing techniques that allow us to create products incorporating design and durability. This product Good Home Solar Floodlight with PIR has a manufacturer’s guarantee of 2 years against manufacturing defects, from the date of purchase (if bought in store) or date of delivery (if bought online), at no additional cost for normal (non-professional or commercial) household use

• To make a claim under this guarantee, you must present your proof of purchase (such as a sales receipt, purchase invoice or other evidence admissible under applicable law), please keep your proof of purchase in a safe place. For this guarantee to apply, the product you purchased must be new, it will not apply to second hand or display products. Unless stated otherwise by applicable law, any replacement product issued under this guarantee will only be guaranteed until expiry of the original period guarantee period.

• This guarantee covers product failures and malfunctions provided the product was used for the purpose for which it is intended and subject to installation, cleaning, care and maintenance in accordance with the information contained in these terms and conditions, in the user manual and standard practice, provided that standard practice does not conflict with the user manual.

• This guarantee does not cover defects and damage caused by normal wear and tear or damage that could be the result of improper use, faulty installation or assembly, neglect, accident, misuse, or modification of the product. Unless stated otherwise by applicable law, this guarantee will not cover, in any case, ancillary costs (shipping, movement, costs of uninstalling and reinstalling, labour etc), or direct and indirect damage.

• If the product is defective, we will replace or refund, within a reasonable time.

• Rights under this guarantee are enforceable in the country in which you purchased this product.
  Guarantee related queries should be addressed to the store you purchased this product from.

• The guarantee is in addition to and does not affect your statutory rights.

Addresses

Manufacturer • Fabricant • Producent •
Producător
UK Manufacturer:
Kingfisher International Products Limited,
3 Sheldon Square, London, W2 6PX,
United Kingdom

EU Manufacturer:
Kingfisher International Products B.V.
Rapenburgerstraat 175E
1011 VM Amsterdam
The Netherlands
www.kingfisher.com/products

www.diy.com
www.screwfix.com
www.screwfix.ie

To view instruction manuals online,
visit www.kingfisher.com/products

IMPORTANT – Please read carefully the separate safety guide before use.

Warning

Tools

What’s In The Box

Installation

To ensure proper product operation, the batteries must first be fully charged for two days MINIMUM. To do this, the product has to be turned off the first two days.

Use

Maintenance

Care

If use of the solar light is not required for a long period of time, it is recommended to switch the product to “OFF” to preserve the battery.
We recommend to shelter this product during long winter periods (snow, rain) in order to preserve the product.

References

• Brico Dépôt : Magasin de bricolage
• Bricolage, jardinage et aménagement de la maison | Castorama
• B&Q | DIY Products at Everyday Low Prices | DIY at B&Q

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>