SierraTeck WT0102PO1 Motion Activated Voice Player User Guide
- June 16, 2024
- SierraTeck
Table of Contents
User Guide
WT0102PO1 Motion Activated Voice Player
This guide will help you hit the ground running in no me!
| Name | Funcon |
|---|---|
| Indicator Light | When moon is detected, light turns on and stays on for |
duraon of playback. Light will also turn on when recording audio
Buon A (Recording button)| Press and hold for 3 seconds unl you hear a
beep, then start recording while keeping buon pressed. Release to stop
recording
Buon B (Playback Button)| Press once to start playback, press again to
stop playback
Power/ Volume Switch| High Volume: Set to top posion
Low Volume: Set to middle posion
Power off: Set to lowest posion
STEP 1: Insert baeries (not included):
-
Remove baery cover and insert 3x AAA 1.5V alkaline baeries, nong the correct polarity
-
Use new alkaline baeries only. Used and/or other baery types may cause unit to not funcon properly
STEP 2: Turn on -
Turn on device by sliding power/volume switch to middle or upper seng (low or high volume)
-
When the device is turned on, it may take a few seconds for the sensor to warm up and start responding.
During this me, it is normal for the device not to detect moon and/or double trigger.
STEP 3: Record Audio -
Press buon “A” and hold for 3 seconds unl you hear a beep. Start recording aer beep and keep buon pressed. Release buon to stop recording. If you hear another beep while recording, it means me is up. Up to 2 minutes of audio can be recorded. Buon “A” must be kept pressed while recording, releasing button will stop recording.
-
To hear back recorded audio, press buon “B”. To stop playback, press buon “B” again
-
If you hear crackling sound, this indicates that your baeries are low, please replace with new baeries
-
We test all units aer manufacturing by pre-recording a human voice, this is normal and does not indicate unit is used
STEP 4: Aach to Wall -
Using the 2 screws provided, aach unit to wall directly or using the ball mount parts supplied
-
Regardless of method chosen, only boom 2 screw holes at back of unit are used, upper one is unused
TIPS:
- For indoor use. External use may result in moisture damaging internals of device and void warranty
- Top right corner of device has openings that resemble microUSB port and microSD card slot. Those openings are for different variaons of this product and have no funcon or use on this unit
If there is any way we can assist or if you’ve encountered any issues whatsoever, please email us, we are here to help and make sure you are 100% sasfied.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>