hardoll 40W Solar Light Outdoor LED Waterproof Garden Indoor Ceiling Lamp User Manual
- June 16, 2024
- hardoll
Table of Contents
Solar Ceiling Light
User’ Manual
Packing
Please check whether ail parts are inside
Test before Installation:
Before install the light, please do the following test first.
(important)
-
Connect the lamp cable with the solar panel cable.Face panel towards the sunlight, the lamp won’t glow,but will charge sunlight.
Unplug the cable and the lamp glows, -
Use remote and press “ON” ,the light glows.
While press “OFF”, the light turns off.
Then the lamp and the remote work normally.
(Note: Need face the remote towards the remote receive in the lamp, or it may not work. )
Remote instruction:
Installation method:
-
Find installation position.
Solar panel need to be installed outside to face enough sunlight.
Lamp shall not be installed in too low position to avoid water.
Generally solar panel can be installed:
1. Placed on the roof
2. fixed on the wall
Notice:
1. Let solar panel face the the direction of strong sunlight.
2. Solar panel should not be blocked by buildings or trees.
3. Solar panel should not be installed under glass or indoor. -
Installation step:
1. First, connect the U-bracket to solar panel with hom screws and long screws.
2. Drill holes in the wall,then put big expansion screws.install solar panel bracket on the wall with expansion screws. Then adjust bracket angle to a suitable one.
3. Drill holes in the wall or ceiling and install the light with long screws for lamp.
4. Connect solar pane! cable and lamp cable, and tighten the round cap.(important)
5. After installation, please check whether all installation points are firm.
Installation Picture:
Notice:
- Please fix the solar panel and lamp instalition position to avoid injuring someone wen the wind blows;
- Ensure that solar pane! are not blocked and are exposed to direct sunlight throughout the day
- Please do not connect inappropriate solar panels, s0 as not to damage the solar lights;
- Please do not disassemble the lamp and board, s0 as not to affact the warranty,
- In order not to affect the use of the lamp, please use it every 3 months and clean the dust .
Sel fcheck:
If lamp cannot work,
check whether remote is out of power or destryoed.
Chec whether lamp Is out of power.
Check whether the cable of lamp and solar panel is loose.
Check whether there’s other light in the solar panel.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>