JinChaiYunHong TX-19KE-C Emitter User Manual

TX-19KE-C Emitter
User Manual

TX-19KE-C Emitter

Transmitter Instruction

Digital matching

Turn on the power while holding down the“1H + 4h” button, 3-5 seconds, release the“1H + 4H” button. Press any button, the fan can work normally, the code is completed. If not, please turn off the power once a minute in a repeat operation
Tips The remote control has completed the learning pairing procedure before leaving the factory. After installation, it can be used directly. If you want to add or replace a new remote control, you need to pair it again.
The receiver wiring instructions

Notices

1. When the emitter is unable to remotely control the receiver ,please check whether the switch batteries are in good control. whether they are fixed properly and whether they run out of use.
2. when the emitter is unable to remotely control the receiver ,please check whether there is other remote control products around the space and check whether the keys are pressed down, because same nature of remote control product  may caused interference with each other resulting in poorreceiving effect. Taking away such articles will normalize the remote control function .(the infracted remote controller are not included).
3. Please use this product under applicable voltage. Too low voltage will lead to failure of the remote controller to work (Please refer to the product label for the voltage range and related parameters).
4. Please take out the batteries if you wall not use this product for a long time .

EMITTER
Model:TX-19Ke-C
Frequency: 433.92MHz
Batteries: LR03-1.5V*2
Made in Chain
Zhongzheng Jinghui
Junhong Optoelectronics
Technologic.,Ltd

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference  that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a  residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there  is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
The devices has been evaluated to meet general RF exposure requirement， the device can be used in portable exposure condition without restriction

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>