TARAMPS G2 Block Part Vehicle Automotive Blocker Instruction Manual
- June 16, 2024
- TARAMPS
Table of Contents
Product Manual BLOCK PART
G2
Installation Scheme
Operation
Block Function:
- Activates when opening and closing the door with the ignition on and not pressing the RESET button.
- After 50 seconds, the LED and the siren goes off if installed (not included), another 20 seconds the progressive block initiates. Dee blockage occurs after another 30 seconds.
- To CANCEL the LOCKOUT, press the RESET button at any time, the LED will 1(once) to indicate the lockout cancellation..
VALET Function:
- Temporarily cancels the Lock function. It is used when leaving the vehicle in a parking lot, without the need to indicate the location of the Reset button (secret) to the valet.
- With the ignition off, hold the Reset button until the LED 2 times (5 seconds).
To cancel the valet function, turn on the ignition and press the Reset button for 1 second, The LED will 1x (once) concancellation.
Technical Features
| Supply Voltage | 9 a 15 Volts |
|---|---|
| Consumption | 1 a 6 mA |
| Engine Lock | Max. 20A |
| Siren Output | Only Use Dedicated Siren |
Warranty terms
TARAMPS, located at Rua Abílio Daguano, 274 Res. Manoel Martins – Alfredo
Marcondes – SP, ZIP 19.180-000, guarantees this product against design,
manufacturing, assembly and/or joint and several defects due to design flaws
that make it unsuitable or inappropriate for its intended use, for a period of
24 months from the date of purchase.
In the event of a defect within the warranty period, TARAMPS’ liability is
limited to repairing or replacing the device manufactured by it.
This warranty excludes:
Products damaged by incorrect installation, water infiltration, tampering by
unauthorized individuals; Scratched or torn warranty seal; Cases where the
product is not used under regular conditions; Defects caused by accessories,
modifications or equipment attached to the product; Natural wear components,
such as batteries and others; The product presents damage resulting from
drops, impacts or the action of agents of nature (floods, lightning, etc.);
Costs of removal and reinstallation of the equipment, as well as its transport
to the technical assistance post;
Damages of any type, resulting from problems with the product, as well as
losses caused by discontinuation of use.
Technical Support
Factory technical assistance department:
Taramps Electronics – Rua: Abílio Daguano, nº 274 – ZIP 19.180-000
Phone Number +55(18) 3266-4050 / 99749-3391
E-mail: service@taramps.com.br
A Taramps reserves the right to change the contents of this manual without
prior notice or obligation to apply the modito previously produced units.
+55 18 3266-4050
08007770990
Manufactured by:
TARAMP S ELECTRONICS LTDA
CNPJ / TAX ID: 11.273.485/0001-03
R. João Silvério, 121• Res. Manoel Martins
Alfredo Marcondes – SP
Made in Brazil
www.taramps.com.br
MN_012493_R02
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>