Girnoor G165 Corded Stick Vacuum Cleaner Instruction Manual

June 16, 2024
GIRNOOR

Girnoor G165 Corded Stick Vacuum Cleaner

Girnoor G165 Corded Stick Vacuum Cleaner

Introduction of Accessories

  • Motorizd Brush
    Introduction of Accessories

  • Brush Tool

For furniture, curtain, ceiling, etc.

  • Storage Rack

  • Crevice Nozzle
    Introduction of Accessories
    For corner or edge places

  • Extention Tube

  • Vacuum Body

  • Dust Bin

  • Pre-Filter

  • Handle

  • Extra HEPA

Installation Guide

Use as stick vacuum cleaner
Assemble the motor with dust bin: Align the mark on the CAP with the unlock sign on the dust bin, then rotate the CAP clockwise until you hear a “click”.
Installation Guide

Connect different accessories for different cleaning purposes
Installation

Plug in the power and press the switch to start working

Installation

If you want to use it as a hand vacuum, just need to insert the accessary that you need directly to the body until you hear a “click”.
Installation

Operating Instruction

Self-standing support
The vacuum cleaner can be self-standing when the floor brush and wand are positioned perpendicular (90 degrees).
Steps lightly on the floor brush with your foot, and then push or pull on the wand/handle until you will hear a “click”.

Storage of power cord
After using the vacuum cleaner, please wind the power cord on the storage pile.

Dust Bin Emptying

  1. Empty the Dust Bin (Do not fill dirt over the MAX mark)

  2. Press the Dust Release Laich
    Dust Bin Emptying

  3. Pour out the dirt

Dissemble The Appliance

  • Press the dust bin release button.
    Dissemble The Appliance

  • Hold the dust bin and rotate the handle part counterclockwise to seperate
    Dissemble The Appliance

  • Remove filters
    Dissemble The Appliance

  • Take out the HEPA filter

Filter Maintenance

Note: The filter needs to be cleaned every 2 weeks, it is recommended to replace the HEPA filter every 2-4 months (weak suction is a sign of cleaning/replacing HEPA)

Clean HEPA with cleaning accessories

Put the filters back into the dust bin.

Clean the filter screen cover with cleaning accessories
Filter Maintenance

Unclog Brush Head

Removal method of brush roller

  1. Disconnect the power supply and slide the brush lock latch to the right as shown in the figure
    Unclog Brush Head

  2. Lift the brush lock latch to take out the brush roller
    Unclog Brush Head

  3. Clean off debris and anything wrapped around the brush roller; Use scissors to remove threads and other foreign matters
    Unclog Brush Head

  4. Wash the brush roller with water
    Unclog Brush Head

  5. Allow to air dry for 24 hours
    Unclog Brush Head

  6. Install the brush roller back into the floor brush and slide the lock latch to the left until it is locked
    Unclog Brush Head

Safety Instruction

PLEASE READ ALL INSTRUCTIONS AND CAUTION MARKINGS IN THIS MANUAL BEFORE USING THIS MACHINE.

Basic precautions should always be followed when using an electrical appliance. Including the following:

WARNING
These warnings apply to the machine, and also where applicable, to all tools, accessories, chargers or adapter.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:

  1. This machine is not suitable for persons (including children) with reduced physical, sensory or reasoning capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the machine by a person responsible for their safety.

  2. Please keep the vacuum cleaner out of the reach of children and keep your children away from the vacuum cleaner for their safety. What’s more, please be more cautious when you use the vacuum cleaner around your children.

  3. Please just follow the guidance in this Manual when taking each step. Don’t take any maintenance measures outsides this manual.

  4. This vacuum cleaner just suitable for dry floor or environment. Please don’t install or use it outdoors or in wet environment such as kitchen or bathroom. What’s more, please don’t touch the plug or any part of the vacuum with your wet hands. Otherwise, it may cause fire and electric shock.

  5. Please stop using the vacuum cleaner and contact us if the cord or plug damaged. The damaged supply cord must be replaced by professional. Replace it by yourself is not be allowed.

  6. If the vacuum cleaner doesn’t work properly, such as get a sharp blow, drop, damaged or drop into water, please stop using it immediately and contact us.

  7. Please do not disassemble or assemble the machine at will, otherwise it may cause machine failure. It also may result in fires or electrocution.

  8. Please don’t use it to pick up the water.

  9. Please do not use to pick up flammable or combustible liquids, such as gasoline, or use in areas where they or their vapors may be present.

  10. Please don’t pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

  11. Please keep hair, loose clothing, fingers, and all parts of the body away from openings and moving parts. Do not point the hose, wand or tools at your eyes and ears or put them in your mouth.

  12. Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.

  13. Please don’t use it before the dust bin and filter are install.

  14. Please unplug from the power when the vacuum cleaner is not in use and before maintenance.

  15. Please be sure to turn off the machine before connecting or disconnecting the motorized brush bar.

  16. Fire Warning:
    Please don’t place this product on or near a cooker or any other hot surface and do not incinerate this appliance even if it is severely damaged.

  17. Please don’t apply any fragrance or scented product to the filter(s) of this machine. The chemicals in such products are known to be flammable and can cause the machine to catch fire.

PLEASE READ THESE INSTRUCTIONS CAREFULLY
THIS MACHINE IS JUST SUITABLE FOR HOUSEHOLD

  • Do not use near open flames.

  • Do not store near heat sources.

  • Do not put hands near the brush bar when the machine is in use.

  • Do not pick up water or liquids.

  • Do not pick up burning objects.

PLEASE READ THE “SAFETY INSTRUCTIONS” IN THIS MANUAL BEFORE USING THE VACUUM CLEANER.

  • Please don’t use outdoors or on wet surfaces, not to vacuum water or other liquids, otherwise electric shock may be caused.
  • Please ensure the machine remains upright when using it. Dirt and debris may be released if it is turned upside down.
  • Please don’t operate it while checking for blockages and avoid personal injury.
  • Please don’t use the vacuum cleaner to clean your car while the car is driving.
  • Please be ensure that there are no pipe work (gas, water, air) or electrical cables, wires or ductwork are located directly behind the mounting area.

CARPETS OR HARD FLOORS

  • Please check the manufacturer’s recommended cleaning instructions before vacuuming your floors, rugs and carpets.
  • The brush bar on the machine can damage certain carpet types and floors. Some carpets will fuzz if a rotating brush bar is used when vacuuming. If this happens, we recommend vacuuming without the motorized floor tool and consulting with your flooring manufacturer.
  • Please check that the underside of the floor tool and its brushes are free from foreign objects that could cause marking before vacuuming highly polished floors.

MACHINE MAINTENENCE

  • Please just follow the guidance in this Manual when taking each step. Don’t take any maintenance measures outsides this manual.
  • Please store the machine indoors. Do not use or store it below 37.4°F (3°C). Ensure the machine is at room temperature before operating.
  • Please clean the machine only with a dry cloth. Do not use any lubricants, cleaning agents, polishes or air fresheners on any part of the machine.

VACUUMING

  • Please don’t use it before the dust bin and filter are install.
  • Fine dirt such as plaster dust or flour should only be vacuumed in very small amounts.
  • Please don’t use the machine to pick up sharp hard objects, small toys, pins, paperclips, etc. They may damage the machine.
  • Some carpets may generate small static charges in the dust bin or wand when vacuuming. These are harmless and won t cause any electrical hazards. To minimize any effect from this, please don’t put your hand or insert any object into the dust bin unless you have first emptied it. Just clean the dust bin with a damp cloth.
  • Please be more carefully when cleaning on stairs.
  • Do not put the machine on chairs, tables and so on.
  • Do not press down on the nozzle with excessive force when using the machine because it may cause damage.
  • On waxed floors the movement of the cleaner head may create an uneven luster. If it happens, just wipe with a damp cloth, polish the area with wax and wait for it to dry.

EMPTYING THE DUST BIN

  • Remove the wand and floor tool in order to make emptying the dust bin easier.
  • To minimize dust/allergen contact when emptying, encase the dust bin tightly in a plastic bag to empty.
  • Remove the dust bin carefully from the bag.
  • Seal the bag tightly, dispose as normal.

CLEANING THE DUST BIN

  • Ensure the machine is disconnected from the power outlet before removing the dust bin.
  • Remove the wand and floor tool.
  • Clean the dust bin with a damp cloth.
  • Do not use detergents, polishes or air fresheners to clean the dust bin.
  • Do not put the dust bin in a dishwasher.
  • Ensure the dust bin is completely dry before replacing.
  • To replace the dust bin, align the tabs on the dust bin with the grooves on the main body and slide upwards into place until hear a “clicks”.

WASHABLE PARTS

Some parts of the vacuum cleaners need to be cleaned regularly. Please follow the instructions below.

Trouble Shooting

Problem Possible cause Solution
Dust escapes from vacuum Filter is missing or installed incorrectly Check

filter for correct installation
Filter is damaged and needs to be replaced| Please contact support@girnoor.com and they will provide you with the purchase link
Dust bin is full| Empty dust bin
The appliance doesn’t work| The suction mouth is blocked| Check and remove blockages
Hand vacuum is not installed properly| Remove hand vacuum and reattach ensuring that it is securely in place.
Abnormal motor sounds| The appliance is blocked(such as tube, suction mouth)| Remove blockages

FAQ

Q: What should I do if my product is short of accessories?
A: Accessories may be lost in transit. You can contact us, we will help you solve problems.
Q: What should I do if I don’t know how to use the vacuum cleaner?
A: You can read the “Product parts introduction” to know how to assemble, or you can contact us, we will help you solve problems.
Q: What should I do if I have any other questions?
A: You can contact us via support@girnoor.com, we will reply you within 24 hours and provide you with the best customer service.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals