gorsun E63 Wireless Headphone User Manual
- June 4, 2024
- gorsun
Table of Contents
E63 Wireless Headphone
**User Manual
**
GORDON
Wireless Headphone
ES3
Specifications
Frequency Response: 20HZ-20KHZ
Impedance: 3 2 ohm
Sensitivity : 853 dB/mW
Working Range: 1Om
Battery capacity: 3 00 mAh
Charging time: = 2 H
working time: = 23 H
Rated Power: 10 mW
Largest Power: 15 m
Speaker Diameter: 40mm
Button Function
” **” Power on/Power off
” +” Volume up: short press Move next: long press
” – ”** Volume down: short press Move previous: long press
Function Description
- Power on: Long press” ****” for more than 3 seconds, the headphone turn on, and enter Bluetooth Mode. The blue and red lights flash alternately.
- Power off: Long press” ****” for more than 3 seconds, the light is off and the headphone turns off.
Button Guide
- Answer: short press” ****” button when being called
- Hang up: short press” ****“button when calling
- Dial back: double click” ****” button.
- Play music: normally short press” ****“button to turn on the smart devices automatically to play music
- Continue to play music after the call: when there is an incoming call, the music will be automatically suspended. After the call, the music will continue playing
Bluetooth Pairing
– Repairing: turn off the Bluetooth function of the connected smart
devices, at this time, the Bluetooth headset and the last matching device got
disconnected, LED light flashed between and blue. and enter the Bluetooth
pairing mode. then turn on the Bluetooth function of the smart devices, and
search the device named”E63″ to get connected, after pairing successfully, the
voice prompts”connected”, and the blue LED is on and flashes slowly.
– Subsequent pairing: 3 seconds after powering on, the headphone will
automatically search and connect to the smart device which paired last lime.
Other Functions
– Warning voice of maximum volume: “Dudu”
– Power saving mode: the headphone will automatically turn off after 5 minutes
of no connection
-TYPE-Cdlarging port, user-friendly.
LED Indicator
| Charging | red LED is on when charging, and blue LED is on after full charged |
|---|---|
| Pairing | Blue and red LED flashes alternately |
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications, However,
there is no guarantee that interference will not occur in a particular
installation. If the equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
— Reorient or relocate the receiving antenna
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Warning :
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
RF warning statement :
The device has been evaluated to meet the general RF exposure requirements.
The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>