PXN HB S Racing Handbrake User Manual

Table of Contents

Product Content

Installation

Remove the grip and install it onto the HB S by rotating it, then tighten it securely.
Use the Hexagonal Open-End Wrench to remove the two screws and nuts on the connecting rod.
Rotate the connecting rod 90 degrees and tighten the screws to adjust the angle.

Method 1 – Racing Stand

Secure the HB S to the racing stand using M5 Allen screws.
Use an M3 Allen wrench to remove the screws on the top cover and side fixing screws.
Use an M3 Allen wrench to remove the two screws on the limit plate.
Flip the limit plate and secure it with screws to complete the stroke adjustment.
Use an M5 Allen wrench to remove the screws and washers on the connecting rod.
Replace the spring/damping gel and install the screws and washers on the connecting rod, then tighten them to complete the force adjustment.

Method 2 – Desktop

Secure the HB S to the desktop using a clamp.
Use an M3 Allen wrench to remove the screws on the top cover and side fixing screws.
Use an M3 Allen wrench to remove the two screws on the limit plate.
Flip the limit plate and secure it with screws to complete the stroke adjustment.
Use an M5 Allen wrench to remove the screws and washers on the connecting rod.
Replace the spring/damping gel and install the screws and washers on the connecting rod, then tighten them to complete the force adjustment.

FAQ

Product Content

$PXN-HB-S-Racing-Handbrake-fig- $1$$

Grip Installation

Remove the grip and install it onto the HB S by rotating it, then tighten it securely. $PXN-HB-S-Racing-Handbrake-fig- $2$$

Method 1 Secure the HB S to the racing stand using M5 Allen screws.
Method 2 Secure the HB S to the desktop using a clamp. $PXN-HB-S-Racing-Handbrake-fig- $3$$

Use on PC

Step 1 Secure the HB S in the appropriate position.
Step 2 Use the USB-B data cable to connect the HB S with the PC and start using it. $PXN-HB-S-Racing-Handbrake-fig- $4$$

Step 1 Use the Hexagonal Open-End Wrench to remove the two screws and nuts on the connecting rod.
Step 2 Rotate the connecting rod 90 degrees and tighten the screws to adjust the angle. $PXN-HB-S-Racing-Handbrake-fig- $5$$

Step 1 Use an M3 Allen wrench to remove the screws on the top cover and side fixing screws.
Step 2 Use an M3 Allen wrench to remove the two screws on the limit plate.
Step 3 Flip the limit plate and secure it with screws to complete the stroke adjustment.
Step 4 Use an M5 Allen wrench to remove the screws and washers on the connecting rod.
Step 5 Replace the spring/ damping gel and install the screws and washers on the connecting rod, then tighten them to complete the force adjustment. $PXN-HB-S-Racing-Handbrake-fig- $6$$

Attention

Please read this user manual carefully before using the product.
Avoid strong shocks or vibration and do not drop.
Do not disassemble, modify and repair by yourself.
Prevent water or other liquids from entering the product to avoid damage.
Avoid storing in humid, high temperature, oily smoke and other places.
Please handle it gently when connect and remove the product.
Children should be under adult’s supervision at all times when using this product.

Product Specifications