Maclean MCE447 Solar LED Lamp User Manual
- June 16, 2024
- MACLEAN
Table of Contents
MCE447
ON – switching on the lamp,
OFF – turning off the lamp,
MODE1 – operating mode 1,
MODE2 – operating mode 2,
MODE3 – operating mode 3
MCE447 Solar LED Lamp
EN Solar LED lamp
Explanation of symbols:
A1 Rated voltage
A2 Protection class III: a product in which protection against electric shock
takes place by means of a safety-related with a total low voltage, the so-
called SELV.
A3 IP54: Protection against access to hazardous parts by wire, protection
against dust, protection against splashing water from any direction
A4 Nominal power of the luminaire
A5 Luminous flux (lm)
A6 Maximum service life
A7 Battery information. Battery in the remote control: CR1220 3V
A8 Battery charging time
A9 Working time (depending on the operating mode) up to 12H
A10 The luminaire is suitable for indoor use and outdoors
A11 Minimum distance to the illuminated object
A12 Temperature range in which the luminaire can operate
A13 The product meets the formal requirements in the EU.
A14 Symbol informing about the requirement of separate waste collection. This
product should be returned to the collection points for waste electrical and
electronic equipment, due to the special form of processing.
A15 Assembly and operation: Before starting work, read the instruction manual
carefully.
Before using for the Firrst time, check the correct mechanical fastening. All
activities related to the assembly and maintenance should be performed with
the power disconnected. The light source in the luminaire cannot be replaced.
The product is started by pressing the ON / OFF button directly on the casing
or the remote control. Switching between operating modes is done with the
button on the housing and the attached remote control. Subject to change. The
product should be periodically cleaned with dry cloths to ensure optimal
charging of the batteries. In the case of outdoor installation, pay attention
to adequate insolation to ensure appropriate charging conditions. Before the
rst use, leave the lamp exposed to sunlight in order to fully
recharge the batteries. Protect against flooding.
NOTE: Do not stare at the LED beam. The manufacturer reserves the right
to introduce design changes and improvements due to technical progress of any
products described in the manual without notifying the user.
A16 Color temperature
A17 Motion sensor: Motion sensor detection angle range: 120°.
Lamp installation height: 1.8-3m. Motion detection speed: 0.6-1.5m/s.
A18: 3 lighting options: 3 operating modes:
MODE 1. The sensor detects movement after dusk by activating the lamp for 20
seconds. 100% power.
MODE 2. The lamp works at 20% after dusk. After motion detection, it turns on
at 100% power for 20 seconds.
MODE 3. The lamp is constantly on 20% of power
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>