IKEA 705.034.08 DIRIGERA Smart Home Lighting Devices Hub Instruction Manual

June 16, 2024
Ikea

Design and Quality
IKEA of Sweden
DIRIGERA

Getting started

Connect the USB cable to the power supply unit and your hub. Then plug the power supply unit into the wall socket.
If you have an Apple device
Go to the App Store and download the IKEA Home smart app. The app will take you through the process of installing your hub and other devices.
If you have an Android device
Go to the Google Play store and download the IKEA Home smart app. The app will take you through the process of installing your hub and other devices.
Your hub’s status lightsIKEA 705.034.08 DIRIGERA Smart Home Lighting
Devices Hub - DIRIGERA

Understanding your hub’s status lights

Ring light – loading
Shown when the hub is connected to power and is starting up. Wait for the light to fill the ring before proceeding with connecting the hub to the app.
Ring light softly pulsing white
This is shown once your hub has finished starting up. You can now follow the instructions in the app to connect your hub.
Centre light constant white
Shown when the hub is connected to the internet and everything is OK.
Centre light double-blinking white
Shown when the hub is disconnected from the internet. You can continue to control your devices through the app and your home WiFi network.
Ring light – spinning white
When your hub is updating or busy processing a large amount of information.
Rebooting your hub
Disconnect and reconnect the power to your hub to reboot it.
The ring light fills to symbolise loading while starting up. This will not delete information on your hub.
Factory resetting
Push a pin into the pinhole on the underside of the hub until the status lights turn off. The centre light will then blink red 4 times when the hub is ready. Note – this deletes all previous hub information.

Adding IKEA Home smart to your hub
Follow the instructions in the app to add “Works with IKEA Home smart” devices to the hub.

Care instructions

Unplug the power supply unit from the power source before cleaning and when the hub is not in use.
To clean the hub and the power supply unit, wipe with a soft cloth moistened with a small amount of mild cleaning agent. Use another soft, dry cloth to wipe dry.
Never submerge the power supply unit or hub in water.
Never use abrasive cleaners or chemical solvents as this can damage the products.

IMPORTANT!

  • The wall socket must be located near the equipment and must be easily accessible.
  • Storage temperature: -20 °C to 25 °C.
  • Operating temperature: 0 °C to 40 °C.
  • Do not leave the hub in direct sunlight or near any heat source, as it may overheat.
  • Do not subject the hub or power supply unit to wet, damp or excessively dusty environments, as this may cause damage.
  • The range between the hub and the receiver is measured in open air.
  • Different building materials and placement of the units can affect the wireless connectivity range.
  • Children should be supervised to ensure that they do not play with the product.
  • This equipment is only suitable for mounting at heights up to 2 m.
  • Recommended precautionary measures and technical data, see the back of the power supply unit.

Product servicing
Do not attempt to repair this product yourself. If you open or remove parts, you may expose yourself to dangerous voltage points or other risks.
Save these instructions for future use.

Technical data

Model: DIRIGERA hub for smart products
Type: E2003
Input: 5.0V DC
Range: 10 m in open air

Power supply unit:
Type:| ICPSW5-10EU-1, ICPSW5-10NA-1
ICPSW5-10IN-1, ICPSW5-10kr-1
ICPSW5-10AU-1
Input:| 100-240 VAC, 50/60 Hz, 0.3A
Output:| 5.0 V DC
Max total load:| 2.0 A, 10.0W

Indoor use only

Operating frequency: Output power:
2400 – 2483.5 MHz 11.8 dBm
2412 – 2472 MHz 17.7 dBm
5180 – 5700 MHz 14.9 dBm

Manufacturer: IKEA of Sweden AB
Address: Box 702, SE-343 81 Älmhult, SWEDEN

Bluetooth®
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by IKEA is under license. Other trademarks and trade names are those of their respective owners.
RF exposure information
According to RF exposure regulations, under normal operations the end user shall refrain from being closer than 20 cm from the device.

**** The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

© Inter IKEA Systems B.V.
2021 AA-2381077-1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals