HPRT HM-T260LR Portable Label Printer Instruction Manual
- June 16, 2024
- HPRT
Table of Contents
**HPRT HM-T260LR Portable Label Printer Instruction Manual
**
Product Introduction
**Appearance and Components
**
Packing List
-
Quick Start Guide
-
Printed
The actual content inside the box shall be based on the actual object.
Product Introduction
Indicator Status
White Abnormal Light State
-
Constant brightness: abnormal
(paper shortage/cover opening/TPH overheating -
Slow flashing: low battery
White Basic State Light
- Flash: Firmware upgrade in progress
- Slow flashing: charging
- Always on: Printer ready/Bluetooth connected
successfully/Bluetooth disconnected /Bluetooth lost
On/Off
Long press the power button for 3 seconds to turn it on/off.
Paper Loading Instruction
-
Use both hands to pry the cover apart on both sides
-
As shown in the following figure, install the paper roll with the thermal side facing outward.
-
Move the paddle switch up and adjust the paper limiter according to the width of the paper roll. After adjustment, press down the paddle switch and lock the paper limiter
-
Pull out a small piece of paper and close the lid.
APP Download
Scan QR code to download the app:
“Here Print” APP
“Here Label” APP
Connect Printing
-
Open the Han code app and click on “My” – “Connect Device”.
Check the list of “Bluetooth devices”, find “HM-T260L-XXXX”, and click to connect. -
Click “New” – “New Label”. Set the label width and height based on the actual size of the label paper
-
Edit the labels as needed, click “Next” after editing, and then print.
Battery charging
If you need to charge, please use a USB Type-C to Type-A cable and connect the
power adapter (self provided, adapter output not higher than 5V/1A) to the
printer for charging.
When the battery level is low, the indicator light will flash (white, flashing
once per second). Please charge in a timely manner. If you continue printing,
the printer may automatically shut down.
Note : You can use a power adapter or computer USB for power supply, and
the adapter is not included when shipping. If consumers use a power adapter
for charging, they should purchase and use a power adapter that has obtained
CCC certification and meets the standard requirements
Online WeChat Customer Service
(Warranty/After Sales/Technical Support)
FCC WARNING
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can ermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.