OLIGHT Oclip Rechargeable EDC Flashlight 300 Lumens Dual Light User Manual

OLIGHT Oclip Rechargeable EDC Flashlight 300 Lumens Dual Light

Product Information

Specifications

(MOONLIGHT), 5h
(REDLIGHT)
Charge Type| USB-C
Cable Length| 0.25m
Input| 5V/1A
Charging Time| About 1.5 hours
Dimensions| (L)48.5(W)21(H)23mm
Weight| 30g/1.06oz
Battery| Rechargeable Li-ion Battery 280mAh 3.7V (1.036Wh)

Product Overview

• Clip-on light with dual light sources
• On/Off Battery Level Indicator
• Magnetic Base
• High-Performance LED
• Red: Charging
• Green: Charging Completed

Usage Instructions

Charge
Connect the USB-C Charging Cable to the charging port of the Oclip. Plug the other end of the cable into a USB power source. The indicator will turn red to indicate charging and green when charging is completed.

On/Off
To turn on the Oclip, press and hold the button for more than 1 second. To turn it off, press and hold the button again.

Lockout/Unlock
To access the lockout mode, when the light is off, press and hold the side switch for about 2 seconds. The light will enter the moonlight mode briefly and then switch off to signal the lockout mode. The red indicator at the center of the switch will be on for a short time to indicate that the light is in lockout mode. To unlock, continue holding the side switch for over one second until the moonlight mode turns on again.

Moonlight Mode
To activate Moonlight mode, press and hold the button for 1 second or more when the flashlight is off. If the last used mode was Moonlight mode, simply press the button to turn it on.

Change Brightness Level (White light mode only)
In the white light mode, long press the button to change the brightness level. The output starts from the current brightness level and changes in the order of Low -> Medium -> High -> Low. Release the button to set the desired brightness level.

Strobe (White light mode only)
To activate Strobe mode in White light mode, triple-press the button quickly.

Red Light Mode
To switch between Red and White light modes, press and hold the button for more than 0.5 seconds.

Change Red Light Mode
In Red light mode, long press the button to change the red light mode.

Battery Indicator
To check the battery level, double-press the button. The indicator will show different colors to indicate the battery level: Green (60-100%), Orange (30-60%), Red (0-30%).

FAQ

• Q: How long does the Oclip runtime last?
  A: The runtime of the Oclip varies depending on the mode used. At room temperature, the runtime is approximately 1 minute (HIGH), 60 minutes (MEDIUM), 90 minutes (LOW), 12 hours (MOONLIGHT), and 5 hours (REDLIGHT). Please note that the runtime may be affected by external temperature and ventilation conditions.

• Q: How long does it take to charge the Oclip?
  A: The Oclip takes about 1.5 hours to fully charge using the included USB-C Charging Cable.

A clip-on light with dual light sources.

IN THE BOX

Specifications

COOL WHITE

• CCT: 5700-6500K
• CRI: 70

The above data are tested per ANSI/NEMA FL 1-2009 standard in Olight’s labs for reference. The tests are performed indoors under a room temperature of 25 degrees celsius with windless conditions. The runtime may vary depending on the external temperature and ventilation conditions, and these biases may affect the results of testing.

USB-C Charging Cable

• Charge Type USB-C
• Cable Length 0.25m
• Input 5V/1A
• Charging Time About 1.5 hours

Multi-language dictionary

• Moonlight
• Low
• Medium
• High
• Strobe
• White light
• Red light
• White light beacon
• Press
• Double press
• Triple press
• Press and hold

Product Overview

Operating instructions

Operating instructions below:

Charge, see Figure 2.

On/Off, see Figure 3.
Single press the button to turn on and off. When turned off, the current mode will be memorized. (Strobe and White Light Beacon can’t be memorized)

Lockout/Unlock, see Figure 4.
When the light is off, press and hold the side switch for about 2 seconds to access the lockout mode. The light will enter the moonlight mode first and then switch off to signal the lockout mode. The red indicator at the center of the switch will be on for a short time to indicate that the light is still in lockout mode. To unlock it, continue holding the side switch for over one second until the moonlight mode is on again.

Moonlight mode, see Figure 5.

• To activate Moonlight mode, press and hold the button for 1 second or more when the flashlight is off.
• If the last used mode was Moonlight mode, simply press the button.

Change brightness level (White light mode only), see Figure 6.
In the white light mode, long press the button to change the brightness. The output starts from the current brightness, and changes in the order of Low->Medium->High->Low. Release the button to select the brightness.(Note: Moonlight mode are not included in this cycle).

Change brightness level

Strobe mode, see Figure 7.
To turn Strobe on, quickly press the button three times or more when the light is off. Press or press and hold to turn off the Strobe.

Strobe (White light mode only)

Red light mode, see Figure 8.
While the light is on or off, double-press to enter red light mode. Single- press to turn off, and the current mode will be memorized when the light is turned on again.

Red light mode

Switch between red and white light mode, see Figure 9.
When the light is on, double press the button to switch between red light mode and white light mode.

Change the red light mode, see Figure 10.
In the red light mode, press and hold for more than 0.5 seconds to switch to red light blink, release the button, and press and hold for more than 0.5 seconds to go back to constant red light.

Turn on the white light beacon, see Figure 11.
Turn on the white light beacon by quickly pressing the button three times when the light is off or in red light mode. To exit the mode, simply press or press and hold the button.

Battery Indicator

Battery Indicator, see Figure 12.

Safety Instruction

DANGER

• Do not disassemble the product.
• Do not throw the product into the fire, it may cause the battery to burn or even explode, causing unpredictable disasters.

CAUTION

• Do not look directly at the light source or shine it into your eyes, as this may cause temporary blindness or permanent damage to your eyes.
• Do not obstruct the lens, or else the energy emitted from the light may cause the object to burn.
• Don’t place, charge, or use this light in a car where the temperature inside may exceed 60°C or in similar environments.
• Do not immerse the product in water or other liquid as it will damage the product.
• Do not place the light in a dusty environment as dust may enter the switch and cause functional failure.
• The clip is magnetic, and the metal powder adsorbed on the surface will affect the function, please clean it immediately.

NOTICE

• Please only use the TYPE-C charging cable to charge the product to avoid damage.
• Charge the product completely before storing it for a long period.
• If the product is carried, or transported, please lock the product.
• When the charging port is not in use, keep the dust cover closed to prevent dust or foreign objects from entering.

REMARK

• Do not put a hot light into any type of fabric bag or fusible plastic container.
• Non-pet toys.
• When the ambient temperature is below 0°C/32.0 °F, the light can only output at the low and medium brightness mode.

EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual, including but not limited to using the product inconsistent with the recommended lockout mode.

WARRANTY

• Within 30 days of purchase: Contact the original seller for repair or replacement.
• Within 2 years of purchase: Contact Olight for repair or replacement.

If you experience quality problems or damage with low-value fittings like lanyards or clips within 30 days of purchase under normal use conditions, please contact our after-sale service. For issues that occur after 30 days or for damage caused by abnormal use conditions, we provide conditional quality assurance as appropriate.

• USA Customer Support
  cs@olightstore.com.

• Global Customer Support
  contact@olightworld.com

• Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China. Made in China.

References

• Olight | Illuminate Your World.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>