Electrolux EFT739X Cooker Hood User Manual
- October 30, 2023
- Electrolux
Table of Contents
Electrolux EFT739X Cooker Hood
WE’RE THINKING OF YOU!
Thank you for purchasing an Electrolux appliance. You’ve chosen a product that
brings with it decades of professional experience and innovation. Ingenious
and stylish, it has been designed with you in mind. So whenever you use it,
you can be safe in the knowledge that you’ll get great results every time.
Welcome to Electrolux.
Visit our website to:
Get usage advice, brochures, trouble shooter, service and repair information:
www.electrolux.com/support
Register your product for better service:
www.registerelectrolux.com
Buy Accessories, Consumables and Original spare parts for your appliance:
www.electrolux.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the
following data available: Model, PNC, Serial Number.
The information can be found on the rating plate.
Warning / Caution-Safety information
General information and tips
Environmental information
Subject to change without notice.
SAFETY INFORMATION AND INSTALLATION
WARNING!
Refer to the separate Installation Instructions booklet for Safety Information
and Installation. Read carefully the Safety chapters before any use or
maintenance of the appliance.
PRODUCT DESCRIPTION
Control panel overview
| Function| Description
---|---|---
| On / Off| Turns the hood on and off.
| First speed| The motor switches to first speed level.
| Second speed| The motor switches to second speed level.
| Third speed| The motor switches to third speed level.
| Maximum speed| The motor switches to maximum speed level.
| Speed boost| The motor switches to maximum speed level. After 5 minutes the
appliance returns to previous setting.
| Breeze| The hood operates on the lowest speed. After 60 minutes the
appliance turns off.
| Filter notification| Reminds to change or clean the charcoal filter and
clean the grease filter.
| Hob²Hood| Indicator of the function to control hood from hob
| Lamp| Turns the lights on and off.
DAILY USE
Using the hood
Check the recommended speed according to the table below.
| While heating up food, cooking with covered pots.
---|---
| While cooking with covered pots on multiple cooking zones or burners, gentle
frying.
| While boiling and frying big quantities of food without a lid, cooking on
multiple cooking zones or burners.
and | While boiling and frying big quantities of food without a lid, big
humidity.
| Refreshes the air in kitchen after cooking at a very low noise level. It can
be activated and de-activated by touching the symbol. The function turns off
automatically after 60 minutes. Use after cooking only.
It is recommended to leave the hood operating for approximately 15 minutes after cooking.
The control Panel is a sensor field. Touch the symbols for 1 second to activate the functions.
To operate the hood:
-
Turn on the appliance by pressing the symbol.
You can now activate the functions. -
To activate the function touch the symbol.
The hoods light works independently to other hood functions. To illuminate the cooking surface touch .
To turn off the appliance press the symbol again.
Hob²Hood function
It is an automatic function which connects the hob with a hood. Both the hob and the hood have an infrared signal communicator. Speed of the fan is defined automatically on basis of mode setting and temperature of the hottest cookware on the hob. You can also operate the fan using the hob manually. The function can be activated from panel of the hob.
For more information how to use the function refer to the hob user manual.
Activating Maximum Motor Speed
When you touch , the Maximum Motor Speed starts to operate for 8 minutes. After that time, the appliance returns to its previous speed settings.
When the function is turned on, additional touch on does not have any effects.
Filter notification
Filter alarm reminds to change or clean the charcoal filter and clean the grease filter. The filter indicator is turned on for 30 seconds if the grease filter must be cleaned. The filter indicator flashes for 30 seconds if the charcoal filter must be replaced or cleaned.
Refer to cleaning the grease filter in care and cleaning chapter.
Refer to cleaning the charcoal filter or replacing the charcoal filter in care and cleaning chapter.
To reset the function touch for 3 seconds.
To activate or deactivate function:
-
Switch on the control panel.
-
Make sure that the icons are turned white.
-
To activate function touch for 3 seconds.
If the function is activated, the filter icon flashes five times. -
To deactivate function touch for 3 seconds.
If the function is deactivated, the filter icon turns on for 4 seconds.
CARE AND CLEANING
Notes on cleaning
Cleaning Agents
| Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water and a
mild detergent.
---|---
After cooking some parts of appliance can get hot. To avoid stains appliance
must be cooled down and dried with clean cloth or paper towels.
Clean stains with a mild detergent.
Keep the hood clean
| Clean the appliance and grease filters each month. Clean the interior and
grease filters carefully from fat. Fat accumulation or other residue may cause
fire. Follow the instructions for cleaning the accessories when filter
notification is on. Refer to Filter notification in daily use chapter.
---|---
Grease filters can be washed in a dishwasher. The dishwasher must be set to a
low temperature and a short cycle. The grease filter may discolour, it has no
influence on the performance of the appliance.
Charcoal filter
| The time of saturation of the charcoal filter varies depending on the type
of cooking and the regularity of cleaning the grease filter. The activated
charcoal filter is not washable, cannot be regenerated and must be replaced
approximately every 4/6 months of operation, or more frequently for
particularly heavy usage.
---|---
Cleaning the grease filter
Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:
-
Press the handle of the mounting clip on the filter panel underneath the hood (1).
-
Slightly tilt the front of the filter downwards (2), then pull.
Repeat the first two steps for all filters. -
Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance. -
To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable.
Replacing the charcoal filter
WARNING!
The charcoal filter is non washable!
To replace the filter:
-
Remove the grease filters from the appliance.
Refer to “Cleaning the grease filter” in this chapter. -
Press the front edge in slot towards the bottom part of the filter. Slightly tilt the front of the filter downwards
-
To install a new filter, perform the same steps in reverse order.
In any case, it is necessary to replace the filters at least every four months.
Replacing the lamp
This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can be replaced by a technician only. In case of any malfunction refer to “Service” in the “Safety Instructions” chapter.
ENVIRONMENTAL CONCERNS
Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office.
http://www.electrolux.com/shop
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>