Shenzhen ZhengYuanTai Technology ZHX-PB26 Power Bank User Guide
- June 16, 2024
- Shenzhen ZhengYuanTai Technology
Table of Contents
Shenzhen ZhengYuanTai Technology ZHX-PB26 Power Bank
Product Diagram
Product Parameters
- Name: Power Bank
- Model: ZHX-PB26
- Battery type: Polymer carp battery
- Battery capacity: 10000mh/3.85V/38.5Wh
- Rated capacity: 6000mAh(5V-2A)
- Type-C port input: 5V-3A; 9V-2A
- Type-C port output: support (PPS) 5-5.9V-3A, 5~11V-2A,
- support (PD3.0/PD2.0) 5V-3A, 9V-2.22A, 12V-1.5A
- USB A port output: 4.5V-SA (SCP); 5V-4.5A(SCP); 5V-3A:9V-2A:12V-1.5A |
- Wireless charging output: 5W/7.5W/10W/15W Max|
- Watch wireless charging output: 3W Max
- Total output: 5V-3A
- Product size: 111 X 69.5 X 21.5mm
- Product weight: approx. 200g
Instructions For Use
- Please check whether your mobile phone is suitable for the fast charging protocol before use, and the charging equipment must meet the fast charging protocol standards to enjoy the fast charging function of this product.
- This product is suitable for iP series 20W fast charging protocol, and also suitable for 18W or 22.5W fast charging protocol charging.
- Use the charger to charge this product: insert the TYPE-C charging cable interface into the TYPE-C interface, turn on the power, and the product enters the charging state.
- If charging the watch, please lightly press the product’s wake-up button once. At this time, the indicator light shows the current battery level, and the watch will start charging wirelessly.
Packing List
- Power bank x1
- User Manual x1
- Charging cable x1
Safety Guidance
- This product uses lithium-ion batteries, overcharge or overdischarge will affect the service life of the product, please charge and disconnect the power supply after charging and fully charging in time.
- Do not disassemble or put this product into the fire without authorization, otherwise it will cause fire or explosion.
- Do not use this product in high temperature, humidity or corrosive liquid for a long time to avoid leakage due to circuit damage.
- If stored for a long time, please keep the electricity of the product at about 80% and store it in a dry and ventilated place.
- Please use this product properly, any extrusion, drop, impact may cause damage and use effect to the product.
- Please keep this product out of reach of children. mobile phone and watch two wireless charger is not supported at the same time.
ISED Statement
This device complies with Industry Canada s license-exempt RSS.
Operation is subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Exposure Information This equipment complies with IC RSS-216 radiation exposure limits set forth for an uncontro-lled environment. This equipment should be installed andoperated with minimum distance 0cm between the radiator and your body. Informations sur l’ exposition aux RF
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interterence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 0cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>