TECHNAXX TX-175 Telescope User Manual
- June 4, 2024
- Technaxx
Table of Contents
TX-175 Telescope
User Manual
TX-175 Telescope
Before using the device the first time, please read the user manual carefully.
Service phone No. for technical support: 01805 012643 (14 cents/minute from
German fixed-line and 42 cents/minute from mobile networks).
Free Email: support@technaxx.de
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capacities, or by persons lacking in experience or knowledge unless they are supervised or instructed on the use of this device by a person responsible for their safety. Children should be supervised to ensure they do not play with this device.
Keep this user manual for future reference or product sharing carefully. Do
the same with the original accessories for this product. In case of warranty,
please contact the dealer or the store where you bought this product.
Warranty 2 years
*Enjoy your product Share your experience and opinion on one of the well-
known internet portals.
**
Features
- Coated objective lenses
- Solid tube
- Height adjustable tripod with handle
Parts list
3 x Eyepieces | H6mm, H 12.5mm, H2Omm |
---|---|
1 x Reversing lens | 1,5 x |
lx 45° prism | For upright picture |
1 x Barlow lens | For better pictures, change the focal length 3 times |
1 x Telescope | 070 focal length 300mm |
1 x Tripod | max. 125cm |
1 x Viewfinder Telescope | 5 x 24 |
1 x Green light filtre | Enables a strong contrast enhancement e.g. on the moon |
1 x Sunlight filter | Reduction of sunlight |
Weight/Dimensions | 1.8kg / 45 x 45 x 11cm |
1 | Dew shield |
---|---|
2 | Objective lens |
3 | Fixing screw |
4 | Holder for finder scope |
5 | Eyepiece extension |
6 | Eyepiece holder |
7 | Focus wheel |
8 | Mounting connection |
9 | spirit level |
10 | Screw |
11 | Locking lever |
12 | Fixing screw |
13 | Fixing screw |
14 | Handle |
15 | Crank screw (adjust height) |
20 | Strut |
21 | Clamping lever |
23 | Rubber foot |
Site location
Choose a dark location to avoid interference of dark adaption throughout
lights. A flat and stable surface is recommended. Do not observe from closed
rooms. Approx. 30 minutes before starting an observation, position the
telescope and the accessories in the desired location to allow temperature
compensation.
Setting up the tripod
Pull out the tripod legs slowly until the tripod bridge is opened completely.
Open the clamping lever for the tripod legs. Pull out the tripod legs to the
desired height. Make sure that the bubble of the circular level is in the
middle of the circle to ensure a horizontal plane stand. Close the clamping
lever for the tripod legs. Loosen the locking screw for the height adjustment.
Pull out the tripod head to the desired height. Tighten the locking screw for
height adjustment by hand.
Mounting the Telescope on the Tripod
Screw the threaded bolt of the tripod head plate into the mounting connection
of the Telescope to attach.
Make sure that the objective lens is pointing to the opposite side of the
handle.
Mounting the scope finder
Loosen fixing screws.
Insert the desired accessory into the eyepiece holder.
Tighten the fixing screw by hand so that the accessory is fixed in a secure
way.
Using eyepieces
The magnification range depends on the focal length of the telescope and the
eyepieces. The magnification can be varied by changing the eyepieces.
Example:
Focal length telecope : Eyepiece focal length = Magnification 300mm : 6mm =
50x
Use an eyepiece with a higher focal length (= lower magnification) when
starting an observation.
Using the prism
The prism will be attached to the telescope between the eyepiece holder and
the eyepiece. It allows for an image reversal to an upright image.
Using Barlow Lens 3X
A Barlow lens is an optical component that is inserted between the eyepiece
and the focuser. Inside it is a minus lens that artificially extends the focal
length of the telescope.
The focal length of the telescope is 300mm, in combination with the Barlow
lens 3X the focal length is extended by a factor of 3.
Focal length: 300mm + Barlow lens 3X corresponds to a focal length of 900mm.
900mm: 6mm = 150 times magnification.
A Barlow lens is an additional component that contains lenses. Each lens
reflects light and absorbs it additionally in the lens material. This results
in less light reaching the eye. Therefore, you should consider when a Barlow
lens makes sense, e.g. for planetary photography.
Using erection eyepiece 1,5X
this lens can be used either directly in the tube or in combination with the
prism. Note that the magnification factor increases by 1.5 times, e.g.
300mm:20=50 *1.5=75 times magnification.
Viewfinder
Image reversal
Our viewfinder does not have an integrated optical image reversal. In this case, the image is visible upside down when looking through the viewfinder. This is not an error!
Observation
Point the telescope at the desired object (e.g. the moon) and look through the viewfinder. Use the telescope’s horizontal and vertical adjustment to center the object in the middle of the viewfinder’s hair cross. Look through the eyepiece for an enlarged view of the object. If necessary, adjust the image sharpness by turning the focussing wheel. The magnification can be enhanced by the change from an eyepiece with a high focal length (e.g. 20mm) to an eyepiece with a lower focal (12.5mm) length.
Troubleshooting
No Image | Remove the caps, change the eyepiece |
---|---|
Blurry image | Adjust the sharpness by turning the focus wheel. |
Bad image | Do not observe through glass, clean lenses |
Care and maintenance
Clean the device only with a dry or slightly damp, lint-free cloth. Do not use
abrasive cleaners to clean the device. This device is a high-precision optical
instrument, so in order to avoid damage, please avoid the following practice:
- Use the device in ultra-high or ultra-low temperatures.
- Keep it or use it in a moist environment for a long.
- Use it in rainfalls or in water.
- Deliver or use it in a strongly shocking environment.
- Avoid fingerprints on optics
Hints
- The device is intended exclusively for private and not for commercial use.
- Only use this device as described in this user manual.
- Do not place any part of this device in water or any other liquid.
- Do not handle the device with wet hands.
- Prevent it comes into contact with hot surfaces or high humidity.
- Keep it away from heat sources to avoid the deformation of plastic parts.
- Never take the objective out of its socket and do not modify its adjustment
Safety Instructions
-
Never look through this device directly at or near the sun.
There is a risk of BLINDING YOURSELF! -
Children should only use this device under supervision.
-
Keep packaging materials (plastic bags, rubber bands, etc.) away from children.
There is a risk of SUFFOCATION. -
Never subject the device – especially the lenses – to direct sunlight. Light ray concentration can cause fires and/or burns.
-
Never take the device apart. Please consult your dealer if there are any defects.
The dealer will contact our service center and send the device in for repair if needed. -
Do not expose the device to high temperatures.
-
The device is intended only for private use.
-
Please heed the privacy of other people.
-
Do not use this device to look into apartments, for example.
Distributor: Technaxx Deutschland GmbH & Co.KG, Konrad-ZuseRing 16-18
61137 Schöneck, Germany,
www.Technaxx.de
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>