iH S PSA5033 Clipon Hering Aid User Guide
- June 16, 2024
- iH S
Table of Contents
iH S PSA5033 Clipon Hering Aid User Guide
- Please read this instruction manual carefully and use it correctly.
- Please read before use.
- Please keep the instruction manual in a safe place and use it when necessary
Package contents and names of each part
Main unit (front)
Main unit (back)
Earphone
Charging Cable
Earplug
Pouch
Charging method
-
Main unit USB socket
-
Plug the USB C socket of the charging cable into the USB socket
-
The LED will glow red while charging. When the LED turns blue, charging is complete
-
How to replace hearing plugs
The earpiece can be removed by pinching the rubber part with your fingers and pulling
Do not hold the cable and pull it
How to use
-
Headphones connect USB socket
-
-
Put the headphones into your ears and press the “+” and “-” buttons to adjust the appropriate volume
If the earpiece is small or large, replace it with another size -
Hold the clip of the main unit between your fingers, then secure it to your breast pocket or anywhere on your clothing
-
Select the switching mode according to the environment
Remark
- Nightly charging guarantee extends battery life
- Free replacement for non-human damage within one year
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could vold your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions.
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement
The device can be used in Omm exposure condition, compliance with exposure
requirements.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>