iH S PSD5040 Clipon Hering Aid User Manual
- June 16, 2024
- iH S
Table of Contents
**iH S PSD5040 Clip-on Herring Aid User Manual
**
PRODUCT OVERVIEW
Power on the TV dongle and plug in theUSBpowerinput
Plug in the 3.5mm jack for TV output todongleinput.Turn on the Main unit power
and turntodonglemode.Check the main unit to hear the dongleconnectvoiceprompt
List to the main unit and get the soundtransferformTVto main unit
Remark
- Nightly charging guarantee extends battery life
- Free replacement for non-human damage within one year
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential Installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
- Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment
This device complies with part 15 of the FCC Rules. Operation is subbed to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirement.
The device can be used in Ohm exposure condition, compliance with exposure
requirements
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>