SOBO WP1000F Aquarium Internal Filter Instruction Manual
- June 16, 2024
- SOBO
Table of Contents
Aquarium Filter PUMP
WP – 1000F
Internal Filter
AC 220-240V 50/601-12 POWER: 15W F.MAX:650L/H
Instruction Manual
WP1000F Aquarium Internal Filter
- The filler sponge absorbs dirt and clears the water
- Suitable for both fresh and salt water
- Fully submersible and ideal for any aquarium filtration
CAUTION
Alwnys disconnect from the electrical socket before performing maintennnce.
Alawys ensure the pump is submerged in water.
Do not lift the pump unit by pulling the wire (Power Cord).
The power supply cord provided for this appliance cannot be replaced.
PERFORMANCE
A clogged or dirty intake screen will generally reduce the performance of the pump.Hence,you must wash away the surrounded debris frequently. If less flow is required, adjust the flow control lever.
MAINTENANCE
Remove the front cover and the impeller cover, followed by the impeller unit.
Use a small brush to clean the cylinder or just wash away the debris under
running water.
REMINDER: If the pump fails to operate, check the following: Check and
ensure there is a consistent power supply to the pump unit.
NOTE: Performing regular maintenance can prolong the life span of the
pump. During installation, ensure the power plug of the pump is inserted to
the power socket outlet at the higher point.
This is to ensure that water will not back flow via the wire to the socket
outlet.
Instruction sheet of water pump and filter
This series ofpumps are used for various types of aquarium as the water cycle power plant. Before installing submersible pump, please read the following instructions in detail, to use it in accordance with the following safety measures and operation requirements.
Safety considerations
- Before normal operation, submersible pump should be controlled in the voltage and frequency of the shown scope, please do not use voltage and frequency beyond the rules;
- Don’t put the submersible pump in flammable and corrosive liquid. Only suitable for both freshwater and marine.
- Submersible pump must be submerged when it work, don’t above the water, otherwise it will cause permanent damage to submersible pump.
- Submersible pump had better not in 35°C above or below the freezing point of water. Otherwise it harm for submersible pump.
- If submersible pump in the power cord damage, to ensure safety, please do not continue to use this pump.
- When submersible pump is working out of water use, make sure pipe fitting tightly, must infuse water as well as emptying air.
Operating considerations
- Power supply shall be cut off before the maintenance.
- Don’t let the submersible pump idling or out of the water for work more than 5 minutes.
- Don’t use the power cord to pull submersible pump directly, otherwise it will make power cord pulled apart or cause drag mark.
- To ensure safety, turn off the pump before remove from the water.
- Maximum diving depth of 3 meter.
- If need to use extra socket, please corresponding to the appropriate rated voltage and current of the power cord.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>