EXTECH LCR203 SMD Component Tweezers Installation Guide
- June 10, 2024
- EXTECH
Table of Contents
EXTECH LCR203 SMD Component Tweezers
Product Information:
The LCR203 SMD Component Tweezers are specially designed for use with the Extech LCR200 LCR meter. These tweezers are used to measure the parameters of surface mount devices (SMD), and come with a cable length of approximately 22 inches (56cm). The tweezers have a maximum component width of 0.75 inches (19mm), making them suitable for a wide range of SMD components. The tweezers are equipped with three banana plugs, namely High, Low, and Guard, that help in accurately measuring and isolating the components. The product is ISO-9001 certified, ensuring that it meets international quality standards.
Product Usage Instructions:
- Plug the High, Low, and Guard banana plugs of the LCR203 SMD Component Tweezers into the corresponding sockets of the Extech LCR200 LCR meter.
- Turn on the LCR200 LCR meter and select the appropriate measurement mode for the component being tested.
- Hold the SMD component between the tips of the tweezer and ensure that it is firmly held in place.
- Bring the tips of the tweezer in contact with the corresponding terminals of the SMD component to be measured.
- Read and record the measurement values displayed on the LCR200 LCR meter.
- Repeat steps 3-5 for other components to be tested.
- After use, disconnect the banana plugs from the sockets and store the LCR203 SMD Component Tweezers in a safe place.
Specifications
These chip component tweezers are for use with the Extech LCR200 LCR meter.
- Cable length: Approximately 22” (56cm)
- Max component width: 0.75” (19mm)
- Terminals: 3 banana plugs, High, Low, Guard
Copyright © 2022 FLIR Systems Inc. All rights reserved including the right of reproduction in whole or in part in any form ISO-9001 Certified www.extech.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>