covetrus ProMAX IV Fluid Warmer User Guide
- June 16, 2024
- covetrus
Table of Contents
covetrus ProMAX IV Fluid Warmer
Important information
This guide provides a quick reference for operating the Covetrus Promax IV
Fluid Warmer.
Please refer to the User Manual for more detailed operations and settings.
Pole Clamp and Carabiner
INSTRUCTIONS FOR USE
-
If using on a pole – Lower the Pole clamp on the back of the fluid warmer and tighten securely on the pole. See figure A
-
If hanging, use the provided carabiner and sling. See figure B
Basic Operation
- Fill the IV line with fluid and remove any air in the line. Open the door and install the IV line. The IV line should be installed towards the end of the line, leaving at least 6 inches of IV line from the patient site. Up to 2 IV lines can be installed in the warmer. (IMPORTANT – DO NOT LEAVE IV LINE IN FLUID WARMER WITH NO FLUID FLOWING)
- Press and hold Power Button for 2 Seconds to Power on (IMPORTANT – DO NOT TURN ON WITH NO FLUID FLOWING IN IV LINE)
- Once turned on, the Fluid Warmer will begin working towards the Set Temp. Adjust temperature by increments of 0.1 or 1
Settings
To access the Menu, press the center green Menu/Enter button
Service Information
All Warranty and Non-Warranty Repair Services will be performed by Triumph
Medical Services.
When sending your pump in for repair, please go to the following link and fill
out the Veterinary RMA Request form: www.triumphmed.com/vet-rma-
request. The shipping address will
be provided when your RMA confirmation is emailed to you. For any questions,
call 888.962.0662, ext 3
CUSTOMER SUPPORT
Questions?
855-724-3461
Distributed by:
Covetrus® North America
400 Metro Place North
Dublin, OH 43017
covetrus.com
Reorder #080699
Made in China
AH-ProMAXIVFluidWarmer-01
REV: 0623
© 2023 Covetrus, Inc. All rights reserved. No copying without consent.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>