Attune 86402 Solar Assist Handle Instruction Manual
- June 16, 2024
- Attune
Table of Contents
Attune 86402 Solar Assist Handle
Product Information
AttuneTM Solar Assist Handle
- Part#: 86402
Specifications
- Product Name: AttuneTM Solar Assist Handle
- Part Number: 86402
- Power Source: Solar
- Handle Material: Not specified
- Dimensions: Not specified
Installation Instructions
Parts/Tools Needed
- Assist Handle
- Mounting Screws (Not Provided)
- Power Drill
Important Safety Instructions
Please read the following safety instructions carefully for your protection
and save them for future reference.
- Determine the installation location and mark screw holes accordingly.
- Using a power drill, create pilot holes at the marked locations.
- If you are installing the solar handle, remove the battery protector and insert the battery into the solar cell box.
- Slide the solar box into the opening with the LEDs facing towards the unit.
- Screw in the handle securely.
- Snap the decorative end caps over the ends of the handle.
Contact Information
3030 Corporate Grove Dr. Hudsonville, MI 49426
- Phone: 616.396.1355
- Website: itc-us.com
FAQ
-
Q: Are the mounting screws provided with the AttuneTM Solar Assist Handle?
A: No, the mounting screws are not provided. You will need to purchase them separately. -
Q: What is the power source for the AttuneTM Solar Assist Handle?
A: The AttuneTM Solar Assist Handle is powered by solar energy. -
Q: Can I use the handle without installing the solar box?
A: Yes, you can use the handle without installing the solar box. However, it will not benefit from the solar-assisted features.
INSTALLATION INSTRUCTIONS
Attune™ Solar Assist Handle
Part#: 86402
PARTS/TOOLS NEEDED
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL IN-STRUCTIONS.
- Make sure there is strong support structure behind the handle. Failure to install into adequate support will void the warranty and runs the risk of pulling the handle out of the wall.
- To avoid a hazard to children, account for all parts and destroy all packing materials.
- Battery will last up to 60 hours on a full charge. Brightness and intensity will decrease over time. Note, partial sunlight or shaded areas will not achieve a full charge on the battery.
- Determine installation location, mark screw holes and drill pilot holes.
- If installing the solar handle, remove the battery protector and insert the battery into the solar cell box. Slide the solar box into the opening with the LEDs facing toward the unit.
- Screw in handle and snap decorative end caps over the ends.
3030 Corporate Grove Dr. Hudsonville, MI 49426
- Phone: 616.396.1355
- itc-us.com
For warranty information please visit www.itc-us.com/warranty-return- policy DOC #: 710-00226 • Rev A • 07/12/2023
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>