aiwa AT-X80X True Wireless Earphone User Manual

June 15, 2024
Aiwa

aiwa AT-X80X True Wireless Earphone User Manual
aiwa AT-X80X True Wireless Earphone

Product Schematic Picture

  • Wireless Headphones

  • charging case

  • Braided Nylon Type-C Charging Cable

  • user’s manual

Packaging List

  • AT-X80X Earbuds
  • Portable Charging Case
  • Braided Nylon Type-C Charging Cable.
  • User’s Manual

Product Specifications

  • Model Number: AT-X80X
  • BT Version: V5.3
  • IP Rating: IPX5
  • Rated voltage/current: 5V/1A
  • Rated Power: 3mW
  • Frequency Response: 20~20KHz
  • Battery: (Earbuds) 3.7V 25 mAh (Charging) 3.7V 200 mAh Supported Profiles: A2DP/AVCTP\AVDTP\AVRCP\HFP\SPP\SMP\ATT GAP\GATT\RFCOMM\SDP\L2CAP PROFILE
  • Impedance: 320 (+15%)
  • Sensitivity: 113 ± 3dBA
  • Transmission Distance: 10 Meters (When No Obstacles)
  • Working Time: About 5 Hours
  • Standby Time (Charging Case+Earbuds): About 260 Days
  • Charging Time (Earbuds Only): About 1.5 Hours
  • Charging Time (Earbuds+Charging Case): About 2~3 Hours
  • Earbuds Weight: 3.0g each
  • Charging Case Weight: 32.5g
    “Charging case holds approximately 2 full earbuds charges.

Schematic diagram of product operation

Product Instructions for Use

Power ON:
Open the charging case cover and remove the earphones. The earphones will automatically power on. During the startup, the earphones’ blue light will stay on for two seconds, and then they will enter pairing mode with the red and blue lights flashing alternately. After a successful pairing, the indicator light on the primary earphone will flash red and blue alternately, while the secondary earphone will have no light effect.

  • Before using it for the first time, make sure the headset is fully charged.”

Power OFF:
When you place the earphones back into the charging case, they will automatically power off and enter the charging state.
The earphones’ red light will stay on continuously.

*AT-X80D will power OFF automatically after 3 minutes of disconnection.

Music Control

Play/Pause: Click left or right touch sensor once (1
Next Song: Click the right touch sensor thrice (3)
Previous Song: Click the left touch sensor thrice(3
Volume +: Click the right touch sensor twice(2)
Volume -: Click the left touch sensor twice(2)

Call Control

Answer/Hang up: Click left or right touch sensor once (1)
Reject Call: Double click left or right touch sensor (2)
Voice Assistant: Long press the left touch sensor button for 2 seconds (2)
Game Mode on/off: Long press the right touch sensor button for 2 seconds (2)

Connecting the Product

Connecting the Product

  1. Turn on Bluetooth (BT) on your mobile device
  2. Remove earphones from the charging case & connect to “AIWA AT-X80X” from your bluetooth device.
  3. The earbuds indicator light will turn off upon successful connection.

Troubleshooting

Left side earbud cannot be linked with Right side earbud

Solution:Place earbuds back into charging case and close the case Re-open the lid after a few seconds. The earbuds would now be linked to each other & is ready to be connected to your mobile device.

If the above solution does not work, please clear earbuds pairing history:

  1. Turn off & disconnect all Bluetooth devices from the earbuds.
  2. Remove ONE (1) earbud from the charging case & click on the touch sensor FOUR (4) times, red light flashes 3 times.
  3. Place that earbud back into the charging case.
  4. Repeat this process for the other earbud.
  5. Remove both earbuds from the charging case & wait for both earbuds to be linked to each other before initiating pairing with your Bluetooth device.

Earbuds are unable to connect to a mobile device.

The earbuds will automatically turn on and enter pairing mode when taken out from the charging case.

The earbuds will connect to the last device they were connected to. If the connecting procedure does not occur automatically, the earbuds need to be manually connected to the mobile device. (Typically occur when the earbuds haven’t been used for a while.)

“If the earbuds are disconnected longer then 3 minutes or the pairing process takes longer than 3 minutes, they will turn off automatically.*

Battery & Charging

Earbuds low battery
When the earphones have low battery, the red light flashes every 5 seconds and prompts “Dong Dong” every 20 seconds. Please place the earphones in the charging box to charge

Low battery of charging case
When the headphones are placed in or removed from the charging box, the green light on the charging box flashes, indicating that the charging box has low battery and needs to be charged. Please use a standard charger to charge it.

Place both earbuds back into the charging case.

  • The charging case indicator light will turn solid green
  • Earbuds are fully charged when the charging case indicator light turns off
  • Approximate earbuds charging time: 1.5 Hrs
    Battery & Charging

While charging: Red light flashes
Full charged: Solid red light
Unplug charging cable: The charging box indicator light is off.
Approximate charging case charging time: 1.5 Hrs

AIWA Electronics International Co., Ltd. Explore more at www.int- aiwa.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals