Vremi VRM010679N Fleece Heating Electric Blanket User Manual
- June 15, 2024
- vremi
Table of Contents
Vremi VRM010679N Fleece Heating Electric Blanket
IMPORTANT SAFETY INSTRUCTIONS
DANGER
Do not sit on the Blanket.
Do not use it while sleeping.
Never position the Blanket underneath the body.
Do not fold the Blanket.
Avoid sharp folds that may damage the product.
Hot surfaces.
To reduce risks of burns, electric shock, fire, and personal injury, this product must be used in accordance with the following instructions:
- Never trap or pinch any of the electrical cords in any way. Make sure the cords are never rested between the mattress and box springs.
- The heated area should always lie flat to prevent overheating.
- If the plug does not fit into your outlet, contact a qualified electrician.
- Be sure that the power supply is used only on 120 V, 60 Hz current supply.
- Make sure the cord from the Controller to your heated product is connected and locked tightly.
- You may use this electric product with any sheets, mattress pads, or other blankets but never in combination with any other electric blankets or electric mattress pads.
- The warming product should never be folded, balled up, or bunched in any way when in use. Any improper use (such as the above actions) may result in overheating and/or permanent wrinkling of the fabric.
- Do not use with generators, power converters, or inverters.
- Never use pins in and around the warming product.
- Cats, dogs, and other pets should always be kept away from the product, as a sharp claw may result in damage to the heatingB element.
- Always turn off the electric current when the warming product is not in use, either by turning off the Controller or unplugging from the wall outlet.
- Wrapping of the cord around the controls may damage the cord. Loop loosely when storing.
- Never iron your warming product.
- Never use dry cleaning fluid on this product. Cleaning solvents may damage the wiring insulation.
- Do not tuck in the wired area of this bedding.
- Do not route electrical cords between the mattress and box spring.
- Do not allow the cords to be pinched.
- Do not use pins. They may damage the electric wiring.
- Keep the control away from drafty areas that may become damp or wet, such as an open window.
- Be sure that this bedding is used on an alternating-current supply circuit of the proper voltage.
- Make sure to unplug, or turn off the appliance when not in use. Excessive heating may result from folding bedding, other than a mattress, when in actual use.
- If improper operation of this bedding is observed, discontinue its use immediately and consult the manufacturer or the dealer regarding its repair.
- For throw blankets only: Do not use with rocking chairs, recliners, chairs with casters or wheels, or other furniture subject to movement.
- Do not tuck the Blanket or supply cord in a sofa or other furniture. All portions of the Blanket or the Controller should be visible at all times.
- This Electric Blanket has a polarized plug (one blade is wider than the other) as a safety feature. This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
- This product is not designed or intended for use by children 12 years of age or younger. Do not use this product with an immobile person or anyone insensitive to heat, such as a person with poor blood circulation.
Blanket Features
- Power Cord
- Blanket Connector
- Control Panel
- Control Connector
Operating Instructions
PLUGGING IN YOUR BLANKET
Before each use, always inspect the product to ensure there is no damage to
the Power Cord, the Control Panel, and the Blanket.
WARNING
- You have to plug the Control Connector into the Blanket Connector. Make sure they fit together tightly. Do not connect them if the Blanket has just been washed. Make sure both Connectors are completely dry when joining them. (* Fig. 1).
- Plug the product into a 120 V AC electrical outlet.
TEMPERATURE SELECTION
-
Press the “On/Off” button on the Control Panel. The Display will illuminate and all icons will display. As a default setting, the Blanket will be set to “85°F”, the lowest heat level. You will also see a “4 h” symbol, indicating the Blanket should automatically switch off after 4 hours.
WARNING
Burns may occur even if you set the temperature at a low level.
Check your skin under the Blanket frequently. -
To change your desired heat level, press the # button for a higher heat level or the button for a lower heat level. You can set it within 3 seconds after turning on, and “SET”
will appear for about 3 seconds, and then display the real-time temperature of the pad. Temperature Selection| Indicator (Temperature)| Heat Elapsed Time
---|---|---
Low| 85°F (29.4°C)| 15 min
2| 90°F (32.2°C)| 20 min
3| 95°F (35°C)| 30 min
4| 100°F (37.8°C)| 40 min
5| 105°F (40.6°C)| 50 min
High| 110°F (43.3°C)| 60 min
DISPLAY OF HEAT LEVEL SETTINGS
PRE-HEATING YOUR BLANKET
NOTE : The maximum heating level can be set is 110°F. The fastest way to
preheat is to set the product at high heating level after turning on it. Set
with the high heating level, and then set with a proper level after the
desired temperature has been reached. It’s recommended not to use with a high
heating level for too long.
IMPORTANT NOTE: The Control Panel displays the internal blanket
temperature, not the external blanket temperature, which will be lower than
that displayed.
USING YOUR BLANKET
- Place the Blanket on top of the body. If the Blanket does not heat evenly, make sure there are no folded areas.
- Turn the product off by pressing the “On/Off” button. Unplug it when not in use.
AUTO-OFF SETTINGS
This Blanket is designed to turn off after a set period. You can set it at 0.5
hour (30 minutes), 1.0 hours, 1.5 hours (90 minutes), 2.0 hours (120 minutes),
2.5 hours (150 minutes), 3.0 hours (180 minutes), 3.5 hours (210 minutes) and
4.0 hours (240 minutes).
- After turning on the Blanket and selecting the desired heat setting, press the © button repeatedly until the desired amount of time is displayed. Time display will flash for3 seconds, and then stay illuminated.
- When the Blanket is turned off, it is reset to default settings (4.0 hours). Follow step 1 to change the Auto Off settings.
WARNING
The Control Connector cannot be covered when in use.
Cleaning & Maintenance
WASHING INSTRUCTIONS
WARNING
Never dry clean or use bleach. Before washing, disconnect all cords. Do not
submerge cords or control unit in water. ( Fig. 2)
-
Machine Wash
Place textile portion without cords in the washing machine. Machine wash on a gentle or delicate cycle. -
Hand Wash
Washing your warming product by hand is the best way to make it last. Wash your textile separately by hand in lukewarm (100°F) water using a small amount of mild laundry soap or detergent. Gently work the textile up and down. Do not rub or scrub. Rinse thoroughly in cool water. Squeeze excess water out by hand; never twist. Do not use a wringer.
DRYING INSTRUCTIONS
WARNING
- Do not use commercial dryers at the laundromat. They may be extra hot and could damage the wiring. Do not iron. Do not plug in until completely dry.
- If the Blanket gets damp by accident, please only use it after it has fully dried.
-
Machine Dry
Put your Electric Blanket into a dryer on low heat and allow it to tumble until dry. Ensure that the textile has enough room to tumble freely. If the product shrinks slightly in during washing, while still damp, gently stretch until it returns to its original size. -
Line Dry
You can line-dry your Blanket by simply draping it over two parallel clotheslines or a shower rod. The head and foot of the Blanket should both be facing down. Do not use clothes pins that could pinch wires.
STORAGE
Store as you would for any other bedding, folded in a dry place.
Troubleshooting
| Problem | Possible Causes & Solutions |
|---|---|
| Blanket will not turn on. | – Make sure that the Plug is plugged securely into |
a 120 V / 60 Hz outlet.
- Make sure that the Connectors are connected and
fully inserted.
The Control Panel displays an “F2” error code.| – The Control Connector and
the Blanket Connector are separated. Unplug the Blanket first, and then
reconnect the Connectors. Make sure they are connected securely and tightly.
Then plug in and re-start the Blanket.
Warranty Information
Vremi® offers a 12-month warranty on all of our products purchased new and
unused from Vremi® LLC or an authorized reseller, with original proof of
purchase and where a defect has arisen, wholly or substantially, as a result
of faulty manufacturing, parts or workmanship during the Warranty Period.
The warranty does not apply where damage is caused by other factors, including
but without limited to:
- normal wear and tear;
- abuse, mishandling, accident or failure to follow operating instructions;
- exposure to liquid or infiltration of foreign particles;
- servicing or modification of the product other than by Vremi.
These are our general terms for the warranty service, but we always urge our customers to reach out to us with any issue, regardless of warranty terms. If you experience an issue with a Vremi® product, please contact us at: support@vremi.com and we will do our best to resolve it for you.
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This product may not cause harmful interference and
- This product must accept any interference received, including interference that may cause undesired operations.
WARNING : This manual is to be used with all items with the model
numbers: VRM010679N
RATING : 120 V AC, 60 Hz, 145 W, 1.2 A, AC ONLY.
WARNING : Keep all plastic bags away from children.
Drop Us A Line
We’re Here To Help:vremi.com/chat
646-490-9904
support@vremi.com
FAQs
Is the Vremi VRM010679N Electric Blanket machine washable?
Yes, the Vremi VRM010679N is typically machine washable. It's important to follow the manufacturer's instructions for washing and drying to maintain the blanket's quality and safety features.
What are the main features of the Vremi VRM010679N Fleece Heating Electric Blanket?
The Vremi VRM010679N features soft fleece material, multiple heat settings, an adjustable thermostat, and is designed for safe, energy-efficient warmth. It may also include a timer function and an auto-off safety feature.
Can the Vremi VRM010679N Electric Blanket be used on all bed sizes?
The Vremi VRM010679N comes in various sizes to fit different beds. It's important to select the size that matches your bed for optimal performance and safety.
How energy efficient is the Vremi VRM010679N Fleece Heating Electric Blanket?
The Vremi VRM010679N is designed to be energy efficient, offering warmth without excessive electricity use. Its adjustable heat settings allow users to choose a comfortable temperature while conserving energy.
How do I control the temperature of the Vremi VRM010679N Electric Blanket?
The Vremi VRM010679N comes with a control unit that allows users to adjust the temperature. Some models might offer a remote control for added convenience.
What safety features are included in the Vremi VRM010679N Electric Blanket?
The Vremi VRM010679N typically includes safety features like overheat protection and an auto-off function to prevent accidents and ensure safe use throughout the night.
Is the Vremi VRM010679N suitable for people with allergies?
The Vremi VRM010679N's fleece material is generally hypoallergenic, making it suitable for most people with allergies. However, it's always best to check the specific material details if you have severe allergies.
Can I use the Vremi VRM010679N Electric Blanket with pets?
While the Vremi VRM010679N is durable, caution should be exercised when using electric blankets around pets to avoid damage and ensure safety.
How long is the warranty period for the Vremi VRM010679N?
The warranty period for the Vremi VRM010679N varies, so it's advisable to check with the retailer or manufacturer for exact details.
What is the price range of the Vremi VRM010679N Fleece Heating Electric Blanket?
The price of the Vremi VRM010679N can vary based on size and retailer. It's recommended to compare prices across different platforms for the best deal.
How does the Vremi VRM010679N compare to other electric blankets in terms of comfort and quality?
The Vremi VRM010679N is often praised for its soft fleece material and reliable heating, making it a competitive option in terms of comfort and quality compared to other electric blankets.
Where can I purchase the Vremi VRM010679N Electric Blanket?
The Vremi VRM010679N can be purchased from various online retailers, department stores, and home goods stores. It's advisable to check multiple sources for availability and pricing.
Download this pdf manual:
Vremi VRM010679N Fleece Heating Electric Blanket User Manual
Reference Link
Vremi VRM010679N Fleece Heating Electric Blanket User Manual-Device. report
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>