SONOS Era 300 Wall Mounts User Manual

Table of Contents

SONOS Era 300 Wall Mounts User Manual

The easy-to-install mount for Sonos Era 300.
Supports the weight of your speaker and secures it in place.
Allows access to ports, buttons, and touch controls, and cleanly routes your speaker’s cable.
Flexibility to position your speaker for best sound.

Important: This wall mount is for use only with Sonos Era 300 (sold separately), and is designed for wall stud installation

Each custom-designed Sonos Era 300 Wall Mount assembly includes:

What you’ll need

Upright wall mounting

Inverted wall mounting (upside down)

Mounting the speaker upside down is recommended if the speaker is installed within 2 feet of a ceiling to optimize downfiring sound.
The speaker can swivel left and right, or tilt up and down.
When wall mounted upside down, the power cable can be routed from above or below.

Locate a wall stud. Place the bracket against the wall using a level to make sure it’s aligned, and mark the screw holes. Remove the bracket.
Pre-drill pilot holes into a stud using a 9/64” drill bit. Place the bracket against the wall with the small arrows pointing up, and secure it to the wall with 2 long wall bracket screws (included) and a power drill or Phillips-head screwdriver.
Thread the power cord through the opening at the back of the mount and plug it into the speaker.
Rotate the speaker 180° so the screw holes are facing up. Attach the speaker platform to the speaker using 2 short speaker mount screws (included).
Align the mount with the bracket keyhole, slide the mount down, and lock it into place. Make sure the wall mount and speaker are securely seated before removing your hands from the speaker.
To adjust for optimal sound, unlock the speaker by rotating the collar on the mount 90° counterclockwise. Reposition the speaker, then rotate the collar 90° clockwise to lock.
Caution: The mount is restricted to certain angles to give you the best possible sound quality. Do not force an adjustment beyond what is easily allowed. Mount inverted

Locate a wall stud. Place the bracket against the wall using a level to make sure it’s aligned, and mark the screw holes. Remove the bracket.
Pre-drill pilot holes into a stud using a 9/64” drill bit. Place the bracket against the wall with the small arrows pointing up, and secure it to the wall with 2 long wall bracket screws (included) and a power drill or Phillips-head screwdriver.
Remove the screw from the mount assembly. Rotate the mount 180 degrees so the screw holes are facing up, then reattach the screw to the mount assembly
Plug the power cord into the speaker. Next, attach the speaker to the mount using the 2 short speaker mount screws (included).
Align the mount with the bracket keyhole, slide the mount down, and lock it into place. Make sure the wall mount and speaker are securely seated before removing your hands from the speaker.
To adjust for optimal sound, unlock the speaker by rotating the collar on the mount 90° counterclockwise. Reposition the speaker, then rotate the collar 90° clockwise to lock.
Caution: The mount is restricted to certain angles to give you the best possible sound quality. Do not force an adjustment beyond what is easily allowed.